HT2310 / CHT2310
7. Operation
STARTING ENGINE
WARNING
The cutting head will start moving upon the engine starts.
1.Release the throttle lever and make sure it is fully back.
2.Set the ignition switch to the “I” position.
b
b
5.Place the unit on a flat, firm place. Keep the cutting head clear of everything around it.
6.While holding the unit firmly, pull out the starter rope quickly until engine fires.
a | a |
[HT2310] | [CHT2310] |
| |
(a) Throttle lever | (b) Ignition switch |
3.Push the primer pump several times until overflown fuel flows out in the clear tube.
7.After the engine has started, allow the engine to warm up. Pull the throttle lever.
STOPPING ENGINE
1.Release the throttle lever and run the engine for half a minute.
2.Shift the ignition switch to the STOP position.
b
b
a | a |
(1) Primer pump | [HT2310] |
[CHT2310] |
4. Move the choke lever to the closed position.
(a) Choke lever (b) Open (c) Close
NOTE
If the engine doesn’t stop after stopping the switch, close the choke so that engine will stop after a little.
