Fuel
WARNING
•Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m(10ft) away from the fueling stop before starting the engine.
■FUEL MIX
•The engine is lubricated by oil mixed into gasoline. Prepare a mixture of unleaded,
Recommended mixing ratio is 32 : 1.
•Make sure to use gasoline with a minimum octane number of 90 ROZ(USA/Canada : pump octane min.87)
•Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.
•Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.
•Exhaust emission are controlled by the fundamental engine parameters and components (eq., carburetion, ignition timing and port timing) without addition of any major hardware or the introduc- tion of an inert material during combus- tion.
32:1 MIXING CHART
GASOLINE | gal. | 1 | 2 | 3 | 4 | 5 |
|
|
|
|
|
|
|
fl.oz | 4 | 8 | 12 | 16 | 20 | |
|
|
|
|
|
|
|
•These engines are certified to operate on unleaded gasoline.
■MIXING FUEL
1.Measure out the quantities of gasoline and oil to be mixed.
2.Put some of the gasoline into a clean, marked fuel container.
3.Pour in all of the oil, cap the container and shake it well.
4.Pour in the rest of gasoline and shake again for one minute.
5.Indicate the contents on outside of container for easy identification.
DO NOT USE :
•Fuel containing no oil (raw gasoline) may cause the engine to become overheated and damaged.
•Gasohol may cause deterioration of rubber and plastic parts and disruption of the engine lubrication.
•Oil for
•Mixed fuels which have been left unused
for a period of one month or more may clog the carburetor or result in the engine failing to operate properly.
■FUELING
1.Unfasten and remove the fuel cap. Put the cap on a clean surface for dirt prevention.
2.Pour fuel into the fuel tank up to 80% of full capacity.
3.Replace the fuel cap and tighten securely. Spilled fuel must be wiped away from the trimmer before starting the engine.
