PSZ2610
6. Set up
MOUNTING ENGINE
1.Push the drive shaft housing toward the clutch housing and rotate it by hand to check that the drive shaft is engaged with the gears.
2.Insert the drive shaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.
3.Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1.Remove the air cleaner cover.
2.Connect the end of the throttle wire to the joint on the top of the carburetor.
CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
ATTACHING THE PRUNING MECHANISM
(1)
(2)
(3)
(4)
(5)
(1) | Main pipe | (2) Transmission |
(3) | Screw hole | (4) Fastening bolt |
(5)Bolt
1.Remove the cap on the end of the main pipe.
2.Remove the screw screwed into the end of the transmission.
3.Insert the end of the gear case into the main pipe.
4.Line up the hole on the end of the transmission into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.
5.Using a wrench, screw in the bolt provided to fix the mecha- nism into place.
A standard package contains the items as shown below.
(1) | Guide bar | (2) | Saw chain |
(3) Transmission | (4) | Sprocket | |
(5) | Chain tension adjust screw | (6) | Nut |
(7) | Chain tensioner nut | (8) | Chain cover |
Install the guide bar and the saw chain on the transmission as follows.
WARNING
The saw chain has very sharp edges. Use protective gloves for safety.
1.Loosen a nut and remove the chain cover.
2.Mount the guide bar then fit the saw chain around the bar and sprocket.
WARNING
Pay attention to the correct direction of the saw chain.
3.Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and fasten the mounting nut to finger tightness.
(1)Hole
(2)Moving direction
(3)Chain tensioner nut
4.Adjust the chain tension by turning the tensioner screw until the tie straps just touch the bottom side of the bar rail.
(1)Chain tension adjusting screw
(a)Loosen
(b)Tighten
