Zonet Technology ZEN3200 manual Hardware Installation, Configuration, Driver Installation

Installation:

Hardware Installation :

1.Turn OFF the computer, unplug the power cord and open the computer case.

2.Pick a free PCI bus master expansion slot and remove the expansion slot cover. Insert the adapter into the slot until it is fully seated. Secure the adapter.

3.Replace the computer cover and connect the network cable to the newly installed network adapter. Reconnect the computer's power cord and plug it into the power outlet.

Configuration:

The Zonet ZEN3200 is automatically configured when you power-on computer, In certain computer, however, you must modify BIOS by entering CMOS ETUP utility to enable PCI Device and map INTA to an appropriate address, Please refer to the system documentation for details on configuration the PCI SYSTEM BIOS.

Driver Installation:

Before you connect adapter to the network, you have to install the network driver first. The driver for each networking operating system is under a separate directory. In the directory, there is a file describing driver's installation procedure.

Boot ROM Installation:

The optional Boot ROM device allows you to connect a diskless workstation to the network. Perform the following steps to install your Boot ROM device:

1.Insert the Boot ROM into the socket on the adapter.

2.Refer to the installation procedure provided by networking operating

system (Options: Some adapters need to run SETUP Utility to enable Boot ROM function)

12-086-00518 Rev:01