3 Select Enabled from the Current Connection drop-down list. (That is, click the arrowhead at the far right of the box to view the items in the list, then select Enabled.)

4 Select your service provider’s Encapsulation setting from the Encapsulation drop-down list. Depending on your selection, do the following:

!If your Encapsulation setting begins with PPP: Enter your Username and Password in the boxes provided. Your Internet service provider should have given you a User ID or User Name (usually your email address or the characters preceding the @ sign in your email address) and a Password. (These are NOT the same User Name and Password you that you used earlier to open the Zoom Configuration Manager.)

Tip:

If you do not know your Username and Password, contact your service provider and tell them that you misplaced the information.

!If your Encapsulation setting begins with 1483 Bridged or 1483 Routed: The Username and Password boxes will automatically disappear from the page because you do not need to enter this information. Continue with step 5.

Important!

If you plan to use a static IP address, you must manually configure the X3 from the WAN Configuration page and not the Basic Setup page. For more information, see Using Static IP Addressing on page 23. Typically, you must make arrangements with (and pay) your Internet service provider for a static IP address.

5 In the VPI and VCI boxes, enter the settings for your service provider.

Chapter 1: Installation Instructions

21