Manuals / ZyXEL Communications / Computer Equipment / Network Card

ZyXEL Communications G-360, G-162 manual FCC Certification, Part 15, Class B

Models: G-162 G-360

1 72

Download 72 pages 44.09 Kb

Page 4

ZyXEL G-162/G-360 User’s Guide

Federal Communications Commission (FCC) Interference Statement

FCC Certification

The United States Federal Communication (FCC) and the Canadian Department of Communications have established certain rules governing the use of electronic equipment.

Part 15, Class B

The device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

•This device may not cause harmful interference.

•This device must accept any interference received, including interference that may cause undesired operations.

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

If this equipment does cause harmful interference to radio/television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and the receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Caution

1.To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons.

2.This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

iv	FCC Statement

Image 4

ZyXEL Communications G-360, G-162 manual FCC Certification, Part 15, Class B

Contents

ZyXEL G-162/G-360 User’s Guide 802.11b/g Wireless LAN AdapterZyXEL G-162/G-360 Users GuideCopyright Copyright 2005 by ZyXEL Communications CorporationDisclaimer TrademarksZyXEL Limited Warranty Online RegistrationPart 15, Class B FCC CertificationFederal Communications Commission FCC Interference Statement Customer Support Table of Contents viii2-15 Chapter 2 Wireless LAN NetworkingTable Of Contents ZyXEL G-162/G-360 User’s GuidePreface About This Users GuideSyntax Conventions Related DocumentationGraphics Icons Key PrefaceWireless Access Point Wireless SignalPage 1.2 ZyXEL G-162/G-360 Hardware and Utility Installation 1.3 Using the ZyXEL Utility to Configure Your NetworkChapter Getting Started 1.1 About Your ZyXEL G-162/G-360Double-clicking on the Z icon will display the following ZyXEL utility window 1.3.1 Site Survey Use Windows Zero Configuration ConfigureConnect Rescanshould use the same SSID whatever your choice is e. Band shows you 802.11b and 802.11g on the 2.4GHz 2.2 Enable CCX Mode refers the Cisco Compatible Extension, which is the certificate-based authentications EAP-TLS, PEAP and LEAP using dynamic keys for data encryption. Check this box will enable PEAP-MS-CHAP-V2, PEAP-GTC, TLS and LEAP. Please see your MIS administrator for these settings when you are about to enable one of these mode. Please refer to Ch4-Configuring Wireless Security for detail WEP-802.1x and WPA-802.1x authentication information. Also, please see the User Guide of Funk Odyssey software for more WPA-enterprise security settings Advanced Mode This screen Bottom Red Rectangle allows you to make changes to the default ways the card operates including advanced 802.11 settings. Unless you are an advanced user and have deep knowledge about each property on this page, it is recommended that you leave them at the default settings. For more information, please refer to section 2.3 and 1.3.2 Profile Profile Pool Active Profiles1.3.3 Link Info Table 1.2 Link Info supporting OTIST, you must also make the same change hereReceive Transmit Connection InformationNetwork Information 1-131.3.4 About ZyXEL WebsiteChapter Wireless LAN Networking 2.1.4 Wireless Network Application2.1 Overview 2.1.1 SSIDAd-Hoc IBSS Figure 2-1 IBSS Exampletype and use the same SSID and channel Infrastructure BSS Figure 2-2 BSS Example2.1.5 Roaming Figure 2-3 Infrastructure Network ExampleFigure 2-5 Wireless LAN Security Levels 2.2 Wireless LAN SecurityFigure 2-4 Roaming Example 2.2.1 Data Encryption with WEP 2.2.2 WPA-PSK and WPA2-PSK Application ExampleFigure 2-6 WPA-PSK/WPA2-PSK Authentication 2.2.3 WPA and WPA2 with RADIUS Application Example2.2.4 IEEE EAP AuthenticationFigure 2-7 WPA/WPA2 with RADIUS Application Example 2.4 RTS/CTS Threshold 2.3 Fragmentation ThresholdFigure 2-8 RTS Threshold 2.5 OTIST One Touch Intelligent Security Technology The wireless adapter must also support OTIST and have OTIST enablednegatively affect the throughput performance Page Chapter Maintenance Maintenance3.1 The About Screen ZyXEL G-162/G-360 User’s Guide3.2 Uninstalling the ZyXEL Utility Aboutnetwork configuration 3.3 Upgrading the ZyXEL UtilityPage 4.1 Configuring Security Chapter Configuring Wireless SecurityAP/Router, it will fail to connect the network 4.2 Configuring WEP 1. Select WEP under Security 2. Select Auto under Authentication Mode3. Click Configure. You will then see the screen below Wireless Security6. Key Format Select either Hex or ASCII to enter the WEP key 4.3 Configuring WPA-PSK 4. Enter the same pass phrase used to configure WPA-PSK on your access point Wireless Security 4.4 Configuring WPA2-PSKZyXEL G-162/G-360 User’s Guide Wireless Security ZyXEL G-162/G-360 User’s Guide4.5 Configuring WEP-802.1x Wireless Security 4.5.1 Configuring WEP-802.1x EAP-LEAPZyXEL G-162/G-360 User’s Guide 4-10 b. Enter login name and password under the Login Name and PasswordWireless Security ZyXEL G-162/G-360 User’s Guide4.5.2 Configuring WEP-802.1x EAP-PEAP-MS-CHAPv2 4-11Wireless Security ZyXEL G-162/G-360 User’s Guide8. Select a certificate from the list, and click OK 4.5.3 Configuring WEP-802.1x PEAP-GTC 4-13Wireless Security ZyXEL G-162/G-360 User’s Guide4-14 b. Enter login name and password under the Login Name and PasswordWireless Security ZyXEL G-162/G-360 User’s Guide4.5.4 Configuring WEP-802.1x EAP-TLS 4-15Wireless Security ZyXEL G-162/G-360 User’s GuideWireless Security 4-16ZyXEL G-162/G-360 User’s Guide 4.6 Configuring WPA-802.1x 4.6.1 Configuring WPA-802.1x EAP-LEAP 4-187. Select WPA under Security 8. Select LEAP under Authentication Mode 9. Click Configure and then you will see the screen below4-19 d. Enter login name and password under the Login Name and PasswordWireless Security ZyXEL G-162/G-360 User’s Guide4.6.2 Configuring WPA-802.1x EAP-PEAP-MS-CHAPv2 4-2010. Select PEAP MS-CHAP-V2 under Authentication protocol 11. Click Configure and then you will see the screen below16. Select a certificate from the list, and click OK 4.6.3 Configuring WPA-802.1x PEAP-GTC 4-225. Select PEAP-GTC under Authentication Mode 6. Click Configure and then you will see the screen below4-23 b. Enter login name and password under the Login Name and PasswordWireless Security ZyXEL G-162/G-360 User’s Guide4.6.4 Configuring WPA-802.1x EAP-TLS 4-24Wireless Security ZyXEL G-162/G-360 User’s GuideWireless Security 4-25ZyXEL G-162/G-360 User’s Guide 4.6.5 Configuring WPA2-802.1x EAP-TLS 4-26Wireless Security ZyXEL G-162/G-360 User’s GuideWireless Security 4-27ZyXEL G-162/G-360 User’s Guide Page Chapter Troubleshooting 5.1 Problems Starting the ZyXEL Utility ProgramTable 5-1 Troubleshooting Starting ZyXEL Utility Program Troubleshooting5.2 Problems with LED Status 5.3 Problems with the Link Status5.4 Problems with Security Settings Table 5-2 Troubleshooting LED Status5.5 Problems Communicating With Other Computers Table 5-5 Troubleshooting Communication ProblemsTroubleshooting ZyXEL G-162/G-360 User’s GuidePage Appendix A Types of EAP Authentication EAP-TTLS Tunneled Transport Layer ServiceEAP-MD5 Message-Digest Algorithm EAP-TLS Transport Layer SecurityComparison of EAP Authentication Types LEAP