IDP Support Notes

Setup IP address of IDP (A, B, C, D, E, F)

1.Configure each IDP device’s IP address.

Since IDP is a bridge device, it only has one IP address for management purpose, IDP also uses this IP address to update signatures and the send system logs through syslog/E-mail/FTP. To configure the system IP address of IDP device, users can choose two methods,

-Through Console

1. Make sure the baud rate/data/parity/stop/flow control settings are as below.

2.Default Login/password is “admin/1234”

3.Issue the following commands on IDP (A) $>set system ip 192.168.1.141

Change ZyWALL IDP 10 IP address OK. $>set system mask 255.255.255.0

Change ZyWALL IDP 10 netmask OK. $>set system gateway 192.168.1.254

Change ZyWALL IDP 10 default gateway OK. $>set system dns 168.95.1.1

Change ZyWALL IDP 10 default DNS server OK.

4.Repeat the step 3 to configure IDP (B, C, D, E, F) according to IP address assignment table. - Through WEB GUI or Telnet

6

All contents copyright (c) 2004 ZyXEL Communications Corporation.