ENGLISH
13
VIf the NWA-3500 cannot communicate with the network, ensure that the
NWA-3500 is using an IP address on the same subnet as the switch /
router.

4 Install the Hardware

4.1 Attaching Antennas
4.2 Hardware Mounting
In general, the best location for the access point is at the center of your intended wireless
coverage area. For better performance, mount the NWA-3500 high up in an area that is
free of obstructions.
Wall-mounting
Do the following to attach your NWA-3500 to a wall.
1Screw two screws (not included) into the wall 80mm apart (see the figure in step 3).
Use screws with 6mm ~ 8mm (0.24" ~ 0.31") wide heads. Do not screw the screws all
the way in to the wall; leave a small gap between the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the
connection cables to run down the back of the NWA-3500.
"Make sure the screws are securely fixed to the wall and strong enough to
hold the weight of the NWA-3500 with the connection cables.
2Adjust the cables.
Screw the antennas clockwise onto the antenna connectors on
the sides of your NWA-3500. The antennas should be
perpendicular to the ground and parallel to each other.
Make sure the antennas are securely screwed onto the antenna
connectors.