1.Point the antenna up.

2.DSL: Use a telephone wire to connect this port to a telephone jack (or the DSL or MODEM jack on a splitter, if one is already installed).

3.ETHERNET 1-4: Use an Ethernet cable to connect a computer to this port for initial configuration and/or Internet access.

4.Use the power adaptor provided with your P-870HN-51b to connect an appropriate power source to this socket.

5.Push the power switch to the on position.

Checking the LEDs

Look at the LEDs at the front panel of the P-870HN-51b.

•The POWER LED blinks during start-up and is green once the P- 870HN-51b is ready.

•Each ETHERNET LED turns on if the corresponding ETHERNET port is properly connected. The LEDs blink when the P-870HN-51b is sending or receiving data through the corresponding ETHERNET port.

•The DSL LED stays on if a physical DSL connection exists.

•The INTERNET LED is green when Internet access is available and blinks when transmitting data.

•The WLAN/WPS LED stays green when the wireless LAN is ready. It blinks when the P-870HN-51b is sending/receiving data through the wireless LAN.

6