Chapter 4 The ENCRYPT Button
2Click the ENCRYPT button on (A) and (C) for 1~2 seconds and within two minutes of each other.
3Wait for about one minute while (A) and (C) connect.
4 Check the LEDs on both (A) and (C). When the power ( 
) and HomePlug ( ) lights stop blinking and the power (
) light shines steadily, the devices are connected.
Figure 21 Two Separate Powerline Networks
B
A
C
Congratulations. You now have two separate powerline networks as shown above.
If the HomePlug ( ) lights on both powerline devices do not light up, the powerline devices are not connected. Repeat the connection process, making certain you press the ENCRYPT buttons for the correct time and within two minutes of each other. If that does not work see Section 7.5 on page 68 for suggestions.
4.4 ENCRYPT Button BehaviorThe following table summarizes the actions that occur when the ENCRYPT button is pressed for specific lengths of time.
Table 3 Time ENCRYPT Button is Pressed and Action
TIME | ACTION | POWER LIGHT BEHAVIOR | HOMEPLUG LIGHT | ||||
BEHAVIOR |
| ||||||
|
|
|
|
|
|
| |
less than 3 | The device joins a network. It | The power ( |
|
| ) light blinks until | The HomePlug ( | ) light turns |
| |||||||
| |||||||
seconds | shares the same network name | the device is connected. This | on if your device is connected to | ||||
| as other devices on the network. | may take a minute. | another powerline device or a | ||||
|
|
|
|
|
| powerline network. |
|
|
|
|
|
|
|
|
|
more than | The device leaves any network | The power ( |
|
| ) light blinks | The HomePlug ( | ) light blinks |
|
| ||||||
|
| ||||||
10 seconds | it is associated with and its | several times and then shines | red one time and then turns off | ||||
| network name assumes a | steadily. |
|
|
| when it disconnects from the | |
| random value. |
|
|
|
| powerline network. |
|
|
|
|
|
|
|
|
|
38 |
| |
| ||
|
|
|