Chapter 6 Powerline Network Setup Tutorial

Figure 43 An Adapter on Your New Network

6Go back to step 3 in this section to set the same, new Network Name for all remote adapters you want to add to your new network.

7Check you have added the adapters correctly by changing the network name for the local adapter. All adapters with the new Network Name now appear in the list of adapters on your network. These adapters are now part of your new network.

Figure 44 Adapters on a New Powerline Network

•If you want to access any of your new powerline networks using the PLA-4xx Series Configuration Utility, change the Network Name on your local adapter to the network name for the network you want to access. The adapters on that network will then display in the adapter table, allowing you to select and configure each one.

6.2Troubleshooting

The HomePlug () LED (light) should light up on your adapter when it successfully connects to other adapters on your network. If it does not, try the following measures.

•Make sure the adapter is plugged in to a power socket and the power socket is turned on.

•Check you have entered the correct network name for your network.

58

 

PLA-4xx Series User’s Guide