Chapter 3 Troubleshooting

3This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send File to display the following screen.

Figure 4 Example Xmodem Upload

Type the configuration file's location, or click Browse to search for it.

Choose the 1K Xmodem protocol.

Then click Send.

4After a successful configuration file upload, type atgo to restart the line card.

Bootbase Version: V1.00 03/23/2005 16:10:06FLASH: AMD 32MHardware Version:Serial Number:RAM: Size = 133120 KbytesZyNOS Version: V3.50(ABE.0)b3 05/11/2005 11:56:26Press any key to enter debug mode within 3 seconds.

...........

Enter Debug Mode

atlcStarting XMODEM upload (CRC mode)....CCCCTotal 393216 bytes received.Erasing...

...........................................................................

.....OKatgo

3.4.2 Uploading the Firmware via Boot Commands

Usually you should use FTP with the MSC to upload the line card’s firmware. If you cannot manage the line card from the MSC, use the following procedure to upload firmware to the line card.

1Obtain the firmware file, unzip it and save it in a folder on your computer.

22

 

GLC1320G-55 User’s Guide