Husqvarna T435 manual Mufﬂer, Throttle lockout

Page 31

MAINTENANCE

Throttle lockout

•Make sure the throttle control is locked at the idle setting when the throttle lockout is released.

•Press the throttle lockout and make sure it returns to its original position when you release it.

•Check that the throttle control and throttle lockout move freely and that the return springs work properly.

•Start the chain saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle control is in the idle position you should check the carburettor idle adjustment.

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

Never use a machine that has a faulty mufﬂer.

English – 31

Image 31

Contents T435 Symbols on the machine KEY to SymbolsSymbols in the operator’s manual Contents Dear Customer IntroductionWhat is what on the chain saw? What is WHAT?Before using a new chain saw General Safety PrecautionsAlways use common sense Personal protective equipment Machine′s safety equipmentChain brake and front hand guard Chain catcher Throttle lockoutVibration damping system General rules Stop switchCutting equipment MufﬂerChain Sharpening your chain and adjusting depth gauge settingCutting equipment designed to reduce kickback BarIncreased if the depth gauge setting is General advice on adjusting depth gauge settingToo large Cause serious or even fatal injury Adjustment of depth gauge settingTensioning the chain Lubricating cutting equipmentChecking wear on cutting equipment Filling with chain oilChecking chain lubrication Chain drive sprocketBar Working with the chain AssemblyFitting the bar and chain Fitting a spike bumperFuel Fuel HandlingLong-term storage Fuel safetyFuelling Transport and storageWarm engine Starting and StoppingStarting and stopping Cold engineStopping General working instructions Basic safety rulesWorking Techniques Before useAlways use a fast cutting speed, i.e. full throttle English General requirements working at height Using the chainsaw in the treePreparing to use the saw in the tree Basic cutting technique Working Techniques Felling direction Felling technique for tree topsLimbing Safe distanceFelling cut Freeing a tree that has fallen badlyCutting trees and branches that are in tension Cutting the trunk into logs How to avoid kickbackWhat is kickback? General adviceCarburettor adjustment MaintenanceGeneral High speed jet H Correctly adjusted carburettorMufﬂer Changing a broken or worn starter cord StarterChanging a broken recoil spring Tensioning the recoil springFitting the starter Must always be replaced Air ﬁlterSpark plug Lubricating the bar tip sprocketRunning when making adjustments Adjustment of the oil pumpCooling system Daily maintenance Weekly maintenance Monthly maintenance Maintenance scheduleTechnical data Cispr 122001, EN ISO Bar and chain combinationsSaw chain ﬁling and ﬁle gauges EC-declaration of conformity Applies to Europe onlyPage Page Page ´z+S?h¶6¨ Page 1151317-26