Husqvarna 1153183-26 manual Bar and chain combinations, Saw chain ﬁling and ﬁle gauges

Page 38

TECHNICAL DATA

Bar and chain combinations

The following cutting attachments are approved for the model Husqvarna 3120XP.

		Bar			Chain

Length, inch	Pitch, inch	Gauge, mm	Max. nose radius	Type		Length, drive links
Length, inch	Pitch, inch	Gauge, mm	Max. nose radius	Type		(no.)
						(no.)

24						76

28						84

30	0,404	1,6	42 mm	Husqvarna H64		92

36						104

42						124

Saw chain ﬁling and ﬁle gauges

38 – English

Image 38

Contents 3120XP Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?Always use common sense General Safety PrecautionsBefore using a new chain saw Chain brake and front hand guard Machine′s safety equipmentPersonal protective equipment General Safety Precautions Right hand guard Throttle lockoutChain catcher Vibration damping systemMufﬂer Stop switchCutting equipment General rulesChain Sharpening your chain and adjusting depth gauge settingBar General information on sharpening cutting teethToo large Increased if the depth gauge setting isAdjustment of depth gauge setting Cause serious or even fatal injury Tensioning the chainLubricating cutting equipment Filling with chain oilNeedle bearing lubrication Checking chain lubricationChain drive sprocket Checking wear on cutting equipmentBar Working with the chain AssemblyFitting the bar and chain Fuel Handling FuelExtra chain oil Fuel safetyFuelling Transport and storage Long-term storageCold engine Starting and StoppingStarting and stopping Warm engineStopping Before use Basic safety rulesWorking Techniques General working instructionsWorking Techniques Limbing Basic cutting techniqueTerms Felling direction Tree felling techniqueSafe distance Directional cuts Clearing the trunk and preparing your retreatFelling cut Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tensionCutting the trunk into logs How to avoid kickbackWhat is kickback? Maintenance CarburettorCorrectly adjusted carburettor High speed jet HChecking the brake trigger Changing a broken or worn starter cord MufﬂerStarter Fitting the starter Tensioning the recoil springChanging a broken recoil spring Lubricating the bar tip sprocket Air ﬁlterSpark plug Needle bearing lubrication Adjustment of the oil pumpRunning when making adjustments Cooling systemMaintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceTechnical Data Technical dataBar and chain combinations Saw chain ﬁling and ﬁle gaugesEN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only 0404/09/2119Page Page Page Page Original instructions 1153183-26