Hustler Turf Super Duty 42, Super 928192, Super Duty 36 owner manual Refer to Fig

Page 25

Hustler Mini Z 36/42 & FasTrak Super Duty 36/42

Maintenance Schedule

Refer to Fig. 4-11

 

WEEKLY

MONTHLY

ANNUALLY OR

SERVICE AT

OR 50

OR 100

500

INTERVALS INDICATED

HOURS

HOURS

HOURS

Verify safety start interlock system

 

Daily

 

Visually inspect unit for loose

 

 

 

hardware and/or damaged parts

 

Daily

 

Visually inspect tires

 

Daily

 

Check oil level, engine (1)

Daily or every 4 hrs.

Clean air intake screen (4)

Daily or every 4 hrs.

Check fuel level

 

Daily

 

Blades - sharpen & securely fastened

 

Daily

 

Discharge chute - securely in place &

 

 

 

in lowest position

 

Daily

 

Clean engine and transaxle

 

 

 

compartment

 

Daily

 

Replace air cleaner paper element (5)

 

As needed

 

 

Change transaxle oil & filter

Every 200 hours or 2 years

Grease deck height pivots

x

 

 

Grease gauge wheel bearings

x

 

 

Change engine oil & filter (1) (3)

x

 

 

Clean cylinder and head fins (a)

x

 

 

Check battery connections

x

 

 

Check tire pressure with a gauge

x

 

 

Check hydraulic oil level

x

 

 

Clean engine exterior (a)

x

 

 

Clean and regap spark plugs (a)

 

x

 

Check pump and deck belt tension

 

 

 

& condition (5)

 

x

 

 

 

 

 

Check fuel and hydraulic lines (6)

 

x

 

Check fuel valve and grommet (6)

 

x

 

Tighten lug nuts on wheels (2)

 

x

 

Change fuel filter

 

 

x

Change hydraulic filter and oil (3)

 

 

x

Replace spark plugs

 

 

x

 

 

 

 

NOTES:

1.Initial oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or dirty conditions and during hot weather periods.

2.Torque initially and after first 2 hours of operation.

3.Change engine oil filter per the engine manufacturer’s recommendations. Refer to Engine Owner’s Manual for recommendations and other maintenance items.

4.Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter element. Replace with a new one.

5.Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Otherwise, replace every 400 hours or 2 years whichever comes first.

6.Check fuel line hoses, fuel valve and grommets for any cracks or leaks

7.Initial system oil and filter change must be after the first 75 hours of use or 1 year whichever comes first. Thereafter, replace filter and oil in each transaxle every 2 years or 200 hours, whichever comes first.

REFERENCES:

a— Refer to Engine Owner’s Manual

NOTE: After completing maintenance cycle (500 hours), repeat cycle.

24

107708_0808

Image 25
Contents Hustler Mini Z FasTrak Super Duty 36/42 General Information 1077080808 What is Covered by this Warranty Limitation of Remedies What is Covered by this Warranty Time Limits Safety Precautions Safety and Instruction Decals Slope Guide 1077080808 Operation Using a rampSafe Operating Practices OperationDo not operate on slopes greater than 15 degrees ChildrenControl Panel Safety start interlock systemControls Control Lever Shown with control levers Neutral positionStopping the engine Engine startingMoving tractor with stalled engine Operating suggestions Driving the tractorSide discharge Chute Three point turn Right control leverStep Step NeutralMower deck operation Deck cutting height adjustmentAnti-scalp wheels 1077080808 Maintenance & Adjustments Electrical system LubricationHydraulic system ZT 2800 integrated Pump/motor Expansion tank FilterEngine oil and filter Fuel systemEngine air filter Approved filter element onlyMower blade maintenance General engine maintenance BeltsControl lever adjustment Seat adjustmentMower blade removal Refer to Fig Viewed from top of unit 1077080808 Troubleshooting 1077080808 Product Literature StoragePreparation of engine for storage New season preparation1077080808 Moving tractor with stalled engine Index1077080808 Hustler Turf Equipment