USING THE BLOWER
To blow away debris on the ground
Fitting the blower tube and nozzle on the blower
!WARNING!
When fitting the blower tube and nozzle, the engine must be switched off and the stop switch must be in the stop position.
The blower tube and nozzle have a bayonet mount. Fit them in the following manner:
1.Press the blower tube (15) against the blower air outlet and turn it 90 degrees until a snap is heard.
2.Fit the nozzle (14) onto the tube (15), and turn it 90 degrees until a snap is heard.
Blowing
Before you begin blowing, put on the required safety equipment.
!WARNING!
When working with the blower, wear the required protecting equipment:
1.Hearing protection.
2.Eye protection.
3.Face mask in dusty environ- ments.
When operating the blower, the blower must be secured to the shoulder strap. The strap should be worn over the shoulder as shown in the adjacent figure.
15
14
14 – English