Husqvarna 225 HBV manual High-velocity nozzle

Page 17

USING THE BLOWER

!WARNING!

Never point the blower nozzle at people or animals. The high-velocity air stream can contain particles that may cause serious injury, especially if the blower has previously been used for vacuuming.

Be careful, particurlarly if left hand operation is applied. Avoid any direct body contact with the exhaust outlet area.

!WARNING!

Never start the blower if the inspection cover is not closed, is damaged or cannot be closed. (Exception: When the vacuum tube is fitted).

Start the blower as described on page 13. Work ac- cording to the following instructions:

1.Never blow air toward fixed objects such as walls, large rocks, automobiles and fences.

2.When working inside corners, blow from the corner and inward toward the centre of the work area. Otherwise, debris can fly up in your face and cause eye injury.

!WARNING!

Do not operate the blower while standing on a ladder or a stand.

3. Never point the blower nozzle at delicate plants.

High-velocity nozzle (21)

The high-velocity nozzle is an accessory of the blower and is not included in the standard supply.

When blowing with greater accuracy and high air stream concentration is necessary, substitute the standard nozzle (14) with the high-velocity nozzle (21).

21

14

English – 15

Image 17
Contents Operator´s manual Svenska Contents Introduction Stop KEY to SymbolsPersonal safety equipment Safety InstructionsPersonal safety Fuel safetyOther safety measures Safety equipmentSafety while operating the blower Blower DescriptionAccessories Throttle lock Stop switchAnti-vibration system Muffler16Other equipment Fuel cap Adjusting the carburetorAir filter ChokeFuel mixture Fuel HandlingGasoline Two-stroke oilFuelling MixtureStarting a cold engine Starting and StoppingStarting a warm engine StoppingTo blow away debris on the ground Using the BlowerFitting the blower tube and nozzle on the blower BlowingHigh-velocity nozzle Vacuuming To vacuum debris from the groundFitting the collection bag with the various vacuum tubes Using the Blower Basic factory settings MaintenanceAdjustment CarburetorCooling system Spark plug Air filterTo change a broken or worn cord Starter deviceTo tension the recoil spring To change the recoil springWeekly maintenance Maintenance scheduleDaily maintenance Monthly maintenance Engine Technical DataYour Warranty Rights Obligations Emission Control Warranty StatementSvenska Svenska Svenska 2000W01