Husqvarna O0803001 manual 3MOUNTING Blower Assembly 4INSTALLING Drive Belt

Page 8

 

ASSEMBLY

3MOUNTING BLOWER ASSEMBLY

4INSTALLING DRIVE BELT

1.Position blower over the discharge tabs on the deck and set blower onto the deck.

2.Be sure the blower is sitting fl ush against the outside of the deck.

NOTE: The rear mount bracket is designed to fi t all deck sizes.

Rear Mount Bracket

52/61 Contact Area

42/48 Contact Area

1.Make sure the tension release lever is forward or disengaged.

2.Place the belt over the pulley on the deck. Refer to illustration for proper routing.

3.Move the tension release arm to the rear and engage in the latch.

Tension Release Arm

Outer Pulley

 

Rear Of Deck

Twist in Belt

52/61 Contact Area

Idler Pulleys

3.Install the front mount bracket to the deck with the pin and hairpin cotter supplied with the kit.

Hairpin Cotter

Pin

Outer Pulley Cover

9

Image 8
Contents Operators Manual Table of Contents Safety Rules Safe Operation Practices for RIDE-ON MowersIII. Children Do notYour Safety is Involved Tools Required Container ContentsUnpacking Instructions 2TRIMMING Blower Assembly1INSTALLING Drive Pulley 3MOUNTING Blower Assembly 4INSTALLING Drive Belt Installing Belt Covers 8INSTALLING Middle Chute Trimming Middle Chute10INSTALLING Bagger Mount Vertical Mount Mufflers11INSTALLING Chute Support 12INSTALLING Weight Kits 13MOUNTING Cover Assembly To Support Assembly BAG System 14MOUNTING Cover Assembly To Support Assembly BAG SystemOperation Tips for Improved BaggingCustomer Responsibilities General RecommendationsParts BAG Assembly 539 Parts NUT, #10-24, Crownlock Torque to 30 LBs 3017 2122 Traction Spring Parts SHIELD, Belt Weight KIT 52 3 BIN Weight KIT 42/48 2 BINWeight KIT 42/48 3 BIN 539 130330 R3 01/22/08