Husqvarna 111750 / HCS1372 manual Caring For Hoses, Cleaning Poly Mesh

Page 14

SERVICE AND MAINTENANCE

Caring For Hoses

Caring For Bags

1.Inspect hoses before each use. If hoses have excessive wear, tears, or punctures, replace immediately.

2.To prolong the life of the hose, periodically ro- tate hose and turn hose end to end. Refer to Preventative Maintenance Schedule in this manual.

3.Avoid twists and sharp turns in the hoses, as they will increase wear on the hoses.

4.Avoid dragging the lower hose along the sides of buildings or other hard surfaces.

Inspect the bags before each use. If bags have excessive wear, tears or punctures, replace im- mediately.

Cleaning Instructions

NOTE: Under normal usage the bag material is subject to deterioration and wear.

Cleaning Poly Mesh

The poly mesh on the collection system is located inside the container hood. For best results, clean poly mesh regularly.

Cleaning Instructions

1.Shut off engine.

2.Release the two (2) rubber latches under the rear of the hood. Open hood and brush debris off of both sides.

3.Close hood and re-latch.

DO NOT USE THE COLLECTION SYSTEM WITHOUT POLY MESH SECURELY IN PLACE.

14

Image 14
Contents Page Husqvarna. All Rights Reserved Index Operators GuideFeatures & Controls Safety Rules General InformationOperation Assembly Unpacking InstructionsRear Guard Strap Hitch Assembly Lanyard Hitch PIN Latch Hood Assembly Rubber Seal Hood Hinge Nyloc NUT Hood Assembly Draw Latch Mount Tabs Draw Latch Keeper Blower/Drive Kit Operation Operating the Collection SystemPreventative Maintenance Schedule Service and MaintenanceCleaning and Washing TransportCleaning Poly Mesh Caring For HosesTroubleshooting Guide Spindle Drive Assembly Parts Illustrations Hood Assembly Hitch Assembly Blower Assembly Blower Assembly Weight KIT Mounting KIT BAG Assembly Drive KIT Assembly Weight BAR, Front Parts DescriptionNUT, 1/2-13, Whizlock LOCKWASHER, 7/16 Page Page