Image IMSG20701, IMSW20701, IMSB20701 Securing The Spa Cover, each end of the spa, cover

Page 12
SECURING THE SPA COVER

SECURING THE SPA COVER

To secure the spa cover, snap the latches on the spa cover into the buckles on the side of the spa.

After the spa cover is

 

 

 

secured, you can fur-

 

 

 

ther tighten it by

 

Adjustment

 

adjusting the self-

 

Flaps

 

 

 

 

attaching flaps on

 

 

 

To lock the buckles, insert the key and turn it clockwise 1/4 turn. To unlock the buckles, insert the key and turn it coun- terclockwise 1/4 turn.

Latch

KeyBuckle

each end of the spa

cover.

Always keep the

buckles locked

when the spa is not

in use. Keep the keys in a safe place, out of the reach of children.

SPA JET OPERATION

B

 

B

 

C

A

E

D

 

Refer to the diagram above. The function of each fea- ture is explained below:

The three fixed thera-jets(A), located on one end of the spa, focus a water massage on your back.

The three adjustable thera-jets(B) can be adjusted for a custom water massage. One of the jets focuses a water massage on your lower back, a second jet focuses a water massage on your upper back, and a third jet near the floor of the spa focuses a water mas- sage on your legs. Note: The adjustable thera-jets can be closed and opened by pushing and pulling the nozzles. If no air flows through the thera-jets when the air control is turned counterclockwise, simply pull the nozzles slightly.

The filter (C) can be removed for cleaning and replacement (see CHECKING AND CLEANING THE FILTER on page 13).

The suction vents (D), located near the floor of the spa, bring water into the pump in order to operate the system. The suction covers should always be in place over the suction vents. Never operate the spa with- out the suction covers in place.

The spa is ozone ready. An optional ozone generator can be installed to utilize the ozone jet (E). Ozone provides a way to help sanitize your spa with minimal chemical treatment.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents QUESTIONS? Model No. IMSW20701 IMSG20701 IMSB20701 Serial NoCUSTOMER HOT LINE Mon.-Fri., 6 a.m.-6 p.m. MSTTABLE OF CONTENTS IMAGE is a registered trademark of ICON Health & Fitness, IncIMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS2. Use the RENEW 207 only as described in this manual 10. Never insert any object into any openingAlways replace and lock the spa cover when the spa is not in use 28. DANGER-To reduce the risk of drowningNever use the RENEW 207 alone Keep pets away from the spa at all timesSAVE THESE INSTRUCTIONS 35. Do not use the RENEW 207 immediately after strenuous exerciseBEFORE YOU BEGIN If you set up the RENEW 207 inside If you set up the RENEW 207 outsideCHOOSING A LOCATION FOR THE RENEW Do not use an extension cord with the RENEWSETUP AND ASSEMBLY TOOLS REQUIRED not included One Phillips screwdriverInsulating Liner USING THE RENEW POSTING THE WARNING SIGNPLUGGING IN THE RENEW TESTING AND TREATING THE WATER USING THE CONSOLESTARTING THE RENEW when the spa is not SECURING THE SPA COVEReach end of the spa coverMAINTENANCE MAINTENANCE SCHEDULECLEANING THE SPA SHELL CHECKING AND CLEANING THE FILTER5. Keep all containers closed tightly when not in use REMOVING AND ATTACHING THE ACCESS COVERWATER CHEMISTRY 2. Never mix different chemicalsWINTER USE AND CARE TROUBLE-SHOOTING 1. SYMPTOM THE SPA WILL NOT OPERATE3. SYMPTOM THE PUMP HUMS 4. SYMPTOM THE PUMP HUMS BUT DOES NOT ROTATE8. SYMPTOM THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW 9. SYMPTOM THE WATER IS NOT BEING CLEANED BY THE FILTER10. SYMPTOM THE WATER LEVEL DROPS PART LIST Model No. IMSW20701, IMSG20701, IMSB20701 DescriptionEXPLODED DRAWING Model No. IMSW20701, IMSG20701, IMSB20701 ORDERING REPLACEMENT PARTS LIMITED HYDROTHERAPY SPA WARRANTYICON HEALTH & FITNESS, INC., 1500 S. 1000 W., LOGAN, UT
Top Page Image Contents