SETUP AND ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
•Place all parts of the spa in a cleared area and remove the packing materials from the spa shell; do not dispose of the packing materials until assembly is completed.
•Assembly requires two people.
•Read each assembly step before you begin.
•During assembly, make sure that all parts are turned as shown in the drawings.
TOOLS REQUIRED (not included):
• One Phillips screwdriver
1.Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous page.
Remove the four screws from the access cover on the console side of the spa. Remove the access cover by sliding it down and then pulling the bottom of it away from the spa. Be careful not to damage the Spa Shell (15).
Remove the Power Cord with the GFCI (9) from inside the spa.
2.Close the valve knob on the drain hose. Tighten the two pump fittings.
Refer to step 1 above.
3.Remove the warning decals (not shown) from the Spa Shell (15). Using a damp cloth, wipe the Spa Shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service the spa. Once the spa is filled, it will have to be drained before it can be moved.
Using a garden hose or other clean water source, begin filling the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level shown at the right. Do not overfill the spa.
1 |
| Console | 15 |
|
|
| Screws |
Screws | Access | 9 | |
|
| ||
|
| Cover |
|
2 |
|
|
|
| Pump |
|
|
| Fittings |
|
|
|
|
| 11 |
| Drain Hose | Valve Knob | |
3 |
| Fill to here | |
|
| ||
| 15 |
|
|
8