Image Imsw20701, Imsg20701, Imsb20701, IMSG20701, IMSW20701, IMSB20701 user manual Insulating Liner

Page 9
Insulating Liner.

4.Attach the nozzle of the included air pump to the valve on the Insulating Liner (4). Fill the Insulating Liner with air. Be careful not to overfill the

Insulating Liner.

Lay the Spa Cover (11) on the floor as shown. Set the Insulating Liner (4) inside the Spa Cover.

Insert one of the four straps on the inside of the Spa Cover (11) through one of the loops on the Insulating Liner (4). Attach the latch on the strap to the buckle on the other end of the strap. Attach the other three straps on the inside of the Spa Cover to the Insulating Liner in the same way.

Place the Spa Cover (11) over the spa, making sure that the cutout in the Insulating Liner (4) is aligned with the Console (not shown).

5.Place the Spa Cover (13) over the spa. Make sure that the Spa Cover is centered.

Snap a Buckle (2) onto each of the eight latches on the Spa Cover (13).

Pull down one of the straps on the Spa Cover (13) and hold the Buckle (2) against the side of the spa. (Note: To position the Buckle correctly, have a sec- ond person hold the strap on the opposite side of the Spa Cover tight.) The Spa Cover must be tight. Do not place the Buckle over the grooves between the wood panels. Refer to the inset drawing. Remove the latch from the Buckle (2). Attach the Buckle to the wood panel with two Buckle Screws

(1).

Attach the other seven Buckles (2) to the wood pan- els in the same way.

Remove the Spa Cover (13) from the spa.

Before using the spa, carefully read USING THE RENEW 207 beginning on page 10.

4

4

Cutout

Loops

Loops

Straps

11

5

Strap

Latch

1

2

13

2

6.Before using the spa, follow the instructions on page 10 to post the included warning sign. Do not allow the spa to be used before the warning sign is posted.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Model No. IMSW20701 IMSG20701 IMSB20701 Serial No QUESTIONS?CUSTOMER HOT LINE Mon.-Fri., 6 a.m.-6 p.m. MSTIMAGE is a registered trademark of ICON Health & Fitness, Inc TABLE OF CONTENTSREAD AND FOLLOW ALL INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS2. Use the RENEW 207 only as described in this manual 10. Never insert any object into any opening28. DANGER-To reduce the risk of drowning Always replace and lock the spa cover when the spa is not in useNever use the RENEW 207 alone Keep pets away from the spa at all times35. Do not use the RENEW 207 immediately after strenuous exercise SAVE THESE INSTRUCTIONSBEFORE YOU BEGIN If you set up the RENEW 207 outside If you set up the RENEW 207 insideCHOOSING A LOCATION FOR THE RENEW Do not use an extension cord with the RENEWTOOLS REQUIRED not included One Phillips screwdriver SETUP AND ASSEMBLYInsulating Liner USING THE RENEW POSTING THE WARNING SIGNPLUGGING IN THE RENEW TESTING AND TREATING THE WATER USING THE CONSOLESTARTING THE RENEW SECURING THE SPA COVER when the spa is noteach end of the spa coverMAINTENANCE SCHEDULE MAINTENANCECLEANING THE SPA SHELL CHECKING AND CLEANING THE FILTERREMOVING AND ATTACHING THE ACCESS COVER 5. Keep all containers closed tightly when not in useWATER CHEMISTRY 2. Never mix different chemicalsWINTER USE AND CARE 1. SYMPTOM THE SPA WILL NOT OPERATE TROUBLE-SHOOTING3. SYMPTOM THE PUMP HUMS 4. SYMPTOM THE PUMP HUMS BUT DOES NOT ROTATE8. SYMPTOM THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW 9. SYMPTOM THE WATER IS NOT BEING CLEANED BY THE FILTER10. SYMPTOM THE WATER LEVEL DROPS Description PART LIST Model No. IMSW20701, IMSG20701, IMSB20701EXPLODED DRAWING Model No. IMSW20701, IMSG20701, IMSB20701 ORDERING REPLACEMENT PARTS LIMITED HYDROTHERAPY SPA WARRANTYICON HEALTH & FITNESS, INC., 1500 S. 1000 W., LOGAN, UT
Top Page Image Contents