Image Imsw20701, Imsg20701, Imsb20701 specification

CHOOSING A LOCATION FOR THE RENEW 207

There are many factors to consider when choosing a location to set up the RENEW 207. These factors vary depending on whether you plan to use the spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to set up the spa.

If you set up the RENEW 207 inside:

1.The RENEW 207 will increase the level of humidi- ty in your home. The location you choose should be well ventilated. You may need to install a venti- lation fan or use a dehumidifier.

2.The location must be close to an electrical outlet.

Do not use an extension cord with the RENEW 207.

3.The RENEW 207 should be close to a source of water.

4.Do not use the RENEW 207 on carpet or other material that may be damaged by moisture. We recommend that you place the spa on a water- and stain-resistant, non-slip surface with a floor drain for any water that may splash from the spa.

5.Be sure that the location you choose is stable. It must be able to support the weight of the RENEW 207 when it is filled with water, plus the weight of the occupants. The spa weighs approximately 1,500 pounds when filled with water.

6.Do not use the RENEW 207 above a finished liv- ing area, due to the risk of water damage.

7.Be sure that there is room around the RENEW

207 to permit servicing of the unit. The dimensions of the spa are: 3’ 7” W x 7’ 6” L x 2’ 5” H. You should allow for this size when choosing the loca- tion.

8.The RENEW 207 is not designed for in-floor installation. However, it is compatible with a deck system that is built flush with the top of the spa, provided you leave access to the motor for ser- vice.

9.Be sure to note any other considerations, such as aesthetics or privacy concerns, that may affect the safety or enjoyment of using the RENEW 207.

If you set up the RENEW 207 outside:

1.Check your local building codes concerning the use of outdoor spas.

2.The location must be close to an electrical outlet.

Do not use an extension cord with the RENEW 207.

3.The RENEW 207 should be close to a source of water.

4.We recommend that you place the RENEW 207 on a water- and stain-resistant, non-slip surface. Do not use the spa on rough or sharp surfaces such as gravel or wood chips.

6.Consider environmental factors such as rain, wind, shade, sunlight, and so forth.

7.You should be able to monitor the use of the RENEW 207 from your home to prevent unautho- rized use by children. You may want to enclose the spa with a fence and self-latching gate to pre- vent unauthorized use.

8.Be sure that there is room around the RENEW

207 to permit servicing of the spa. The dimensions of the spa are: 3’ 7” W x 7’ 6” L x 2’ 5” H. You should allow for this size when choosing the loca- tion.

9.The RENEW 207 is not designed for in-ground installation. However, it is compatible with a deck system that is built flush with the top of the spa, provided you leave access to the motor for ser- vice.

10.Be sure to note any other considerations, such as aesthetics or privacy concerns, that may affect the safety or enjoyment of using the RENEW 207.