Image IMHS81590 Choosing a Location for the Hydrotherapy Spa, If you set up the Renew 815 inside

Page 6

Choosing a Location for the Hydrotherapy Spa

There are many factors to consider when choosing a location to set up the RENEW 815. These factors vary depending on whether you use the RENEW 815 inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the RENEW 815.

If you set up the RENEW 815 inside:

1.The RENEW 815 will increase the level of humidi- ty in your home. The location you choose should be well ventilated. You may need to install a venti- lation fan or use a dehumidifier.

2.The location must be close to an electrical outlet.

An extension cord cannot be used with the RENEW 815.

3.The RENEW 815 should be close to a source of water.

4.Do not use the RENEW 815 on carpet or other material that may be damaged by moisture. We recommend that you place the RENEW 815 on a water- and stain-resistant, non-slip surface with a floor drain for any water that may splash from the RENEW 815.

5.Be sure that the location you choose is stable. It must be able to support the weight of the RENEW 815 when it is filled with water, plus the weight of the occupants. The RENEW 815 weighs approxi- mately 2,350 pounds when filled with water.

6.Do not use the RENEW 815 above a finished liv- ing area, due to the risk of water damage.

7.Be sure that there is room around the RENEW

815 to permit servicing of the unit. The diameter of the tub is 63Ó. You should allow for this size, plus the size of the spa jet unit plus room to remove the cover, when choosing the location.

8.Be sure to note any other considerations, such as aesthetics or privacy concerns, that may affect the safety or enjoyment of using the RENEW 815.

If you set up the RENEW 815 outside:

1.You should check your local building codes con- cerning the use of outdoor spas.

2.The location must be close to an electrical outlet.

An extension cord cannot be used with the RENEW 815.

3.The RENEW 815 should be close to a source of water.

4.We recommend that you place the RENEW 815 on a water and stain-resistant, non-slip surface.

5.Be sure that the location you choose is stable. It must be able to support the weight of the RENEW 815 when it is filled with water, plus the weight of the occupants. The RENEW 815 weighs approxi- mately 2,350 pounds when filled with water.

6.Think about environmental factors, such as rain, wind, shade, sunlight, and so forth.

7.You should be able to monitor the use of the RENEW 815 from your home, to prevent unautho- rized use by children.

8.Be sure that there is room around the RENEW

815 to permit servicing of the unit. The diameter of the tub is 63Ó. You should allow for this size, plus the size of the spa jet unit plus room to remove the cover, when choosing the location.

9.Be sure to note any other considerations, such as aesthetics or privacy concerns, which may affect the safety or enjoyment of using the RENEW 815.

6

Image 6
Contents Model No. IMHS81590 Serial No Customer HOT LineTable of Contents Important Safety Instructions Read and Follow ALL InstructionsPage Before You Begin Choosing a Location for the Hydrotherapy Spa If you set up the Renew 815 insideIf you set up the Renew 815 outside An extension cord cannot be used with the RenewAssembly Schematic View from the OutsideCross Section Rings Threaded Collar Page Priming the SPA JET Unit Using the Hydrotherapy SpaTesting and Treating the Water Plugging in the RenewSecuring the SPA Cover Cleaning the FilterHeating System of Your SPA SPA JET Unit OperationUsing the Console Draining the RenewDraining the Pump Maintenance Trouble-shooting Symptom the Water Level Drops Symptom the SPA JET Unit Cavitates During USESymptom the Water is not Being Cleaned by the Filter Symptom the Inflatable SPA Liner Loses AIROrdering Replacement Parts Limited 90 Day Massage Spa WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Location of the Spa Part LISTÑModel No. IMHS81590 Qty DescriptionLit Pack Parts Bag Qty Description