Image 831.10815 Choosing a Location for the Hydrotherapy Spa, If you set up the spa inside

Page 6

Choosing a Location for the Hydrotherapy Spa

There are many factors to consider when choosing a location to set up the spa. These factors vary depending on whether you use the spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the spa.

If you set up the spa inside:

1.The spa will increase the level of humidity in your home. The location you choose should be well ventilated. You may need to install a ventilation fan or use a dehumidifier.

2.The location must be close to an electrical outlet.

An extension cord cannot be used with the spa

3.The spa should be close to a source of water.

4.Do not use the spa on carpet or other material

that may be damaged by moisture. We recom-

mend that you place the spa on a water and stain resistant, non-slip surface with a floor drain for any water that may splash from the spa.

5.Be sure that the location you choose is stable. It must be able to support the weight of the spa when it is filled with water, plus the weight of the occupants. The spa weighs approximately 2,339 pounds when filled with water.

6.Do not use the spa above a finished living area, due to the risk of water damage.

7.Be sure that there is room around the spa to per-

mit servicing of the unit. The diameter of the tub is 69”. You should allow for this size, plus the size of the spa jet unit plus room to remove the cover,

when choosing the location.

8.Be sure to note any other considerations, such as aesthetics or privacy concerns, that may affect the safety or enjoyment of using the spa.

If you set up the spa outside:

1.You should check your local building codes con- cerning the use of outdoor spas.

2.The location must be close to an electrical outlet.

An extension cord cannot be used with the spa.

3.The spa should be close to a source of water.

4.We recommend that you place the spa on a water

and stain resistant, non-slip surface.

5.Be sure that the location you choose is stable. It must be able to support the weight of the spa when it is filled with water, plus the weight of the occupants. the spa weighs approximately 2,339 pounds when filled with water.

6.Think about environmental factors, such as rain, wind, shade, sunlight, and so forth.

7.You should be able to monitor the use of the spa from your home, to prevent unauthorized use by children.

8.Be sure that there is room around the spa to per- mit servicing of the unit. The diameter of the tub is 69”. You should allow for this size, plus the size of the spa jet unit plus room to remove the cover,

when choosing the location.

9.Be sure to note any other considerations, such as aesthetics or privacy concerns, which may affect the safety or enjoyment of using the spa.

6

Image 6
Contents Excluding holidays Model No Serial NoCustomer HOT Line Sears CANADA, INC., TORONTO, Ontario M5B 2B8Table of Contents Important Safety Instructions Keep all chemicals away from children and petsSee Priming the SPA JET Unit on Never use the spa alone Using the spaHas been repaired or replaced by a qualified electrician Keep pets away from the spa at all timesBefore You Begin Choosing a Location for the Hydrotherapy Spa If you set up the spa insideIf you set up the spa outside An extension cord cannot be used with the spaAssembly CrossSection Pushed fully through the vinyl liner Drawing 4ALine. Do not overfill the spa Priming the SPA JET Unit Using the Hydrotherapy SpaTesting and Treating the Water Plugging in the SPASecuring the SPA Cover Heating System of Your SPASPA JET Unit Operation ImporDraining the SPA Using the ConsoleDraining the Pump TurnMaintenance Symptom the Pump Hums Trouble-shootingSymptom the SPA will not Operate Symptom the Water Pulsates or There is Minimum Water FlowSymptom the SPA Pump Loses ITS Prime Symptom the Water is not Being Cleaned by the FilterSymptom the Water Level Drops Be kept outdoors in cold weather, you mustPage Page Customer Record Model NoLimited 90 Day Spa Warranty Is a registered trademark of Icon Health & Fitness, Inc Ordering Replacement PartsModel Number of the product Name of the product Image Part No R1199AChoosing a Location for the Spa Cleaning and Maintaining the SpaCustomer Service Plugging in the SpaQty Lit Pack Qty831.108150