Image 831.10815 user manual Assembly, Cross, Section

Page 7

Assembly

Before beginning assembly, carefully read the following information and instructions:

•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Read all assembly steps before you begin.

•Assembly requires only the included air pump. Note: The included flat wrench is not required for assembly. The flat wrench is used to remove the filter cap (see pages 10 and 11).

•Make sure that all parts are oriented as shown in the drawings.

	1. Before beginning assembly, be sure that you			1A
	have read and understand the information in the			1A	29
	have read and understand the information in the
	box above and on page 6.
	box above and on page 6.
	Place the Surround Bottom (45) and the pre-
	attached Spa Surround (9) on the ground in the				Holes
	location you have chosen for assembly. Unfold the
	Spa Surround until it is round.
	Open the Inflatable Liner (29). Lay the floor of the
	Inflatable Liner (the side with the triangular pattern)
	on the bottom of the Spa Surround (9). Pull the liner
	wall up,	making sure that the three indicated
	holes in the Inflatable Liner are centered in the
	cutout in the Spa Surround		.
					Cutout
					Fastener
					Strip
					9
					45
	Attach the flap on the top edge of the Inflatable Liner			1B	View from the Outside
	(29) to the fastener strip on the edge of the Spa			1B	View from the Outside
	(29) to the fastener strip on the edge of the Spa				Holes in Inflatable Liner
	Surround (9). Start the flap where the fastener strip				Holes in Inflatable Liner
	starts and pull the flap tight as you go around.			Make	Cross
	sure the three holes in the Inflatable Liner are				Cross
	centered in the cutout in the Spa Surround (9),				Section
	as shown in the inset drawing.
					Cutout
					29
					Flap
					9
					Fastener Strip
				7

Image 7

Contents Sears CANADA, INC., TORONTO, Ontario M5B 2B8 Model No Serial NoCustomer HOT Line Excluding holidaysTable of Contents Keep all chemicals away from children and pets Important Safety InstructionsSee Priming the SPA JET Unit on Keep pets away from the spa at all times Using the spaHas been repaired or replaced by a qualified electrician Never use the spa aloneBefore You Begin An extension cord cannot be used with the spa If you set up the spa insideIf you set up the spa outside Choosing a Location for the Hydrotherapy SpaCross AssemblySection Drawing 4A Pushed fully through the vinyl linerLine. Do not overfill the spa Plugging in the SPA Using the Hydrotherapy SpaTesting and Treating the Water Priming the SPA JET UnitImpor Heating System of Your SPASPA JET Unit Operation Securing the SPA CoverTurn Using the ConsoleDraining the Pump Draining the SPAMaintenance Symptom the Water Pulsates or There is Minimum Water Flow Trouble-shootingSymptom the SPA will not Operate Symptom the Pump HumsBe kept outdoors in cold weather, you must Symptom the Water is not Being Cleaned by the FilterSymptom the Water Level Drops Symptom the SPA Pump Loses ITS PrimePage Page Model No Customer RecordLimited 90 Day Spa Warranty Part No R1199A Ordering Replacement PartsModel Number of the product Name of the product Image Is a registered trademark of Icon Health & Fitness, IncPlugging in the Spa Cleaning and Maintaining the SpaCustomer Service Choosing a Location for the SpaLit Pack Qty Qty831.108150