Assembly
Before beginning assembly, carefully read the following information and instructions:
¥Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dis- pose of the packing materials until assembly is completed and the spa is operating.
¥During assembly, make sure that all parts are oriented as shown in the drawings.
¥Read each assembly step before you begin.
¥Tighten all parts as you assemble them, unless instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included):
¥One (1) phillips screwdriver 
¥You may also need a small amount of soap or water.
A wire connector is provided on the pump motor of the spa to connect a minimum No. 8 AWG (804 mm2) solid copper conductor between the spa and any metal equipment, electrical enclosure made of metal, metal water pipes, or conduit within five feet of the spa.
1.Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous two pages.
Refer to the drawing on page 6 and locate the slotted Access Panel (2). Remove the four #6 x 1 1/4Ó Wood Screws (7) from the Access Panel. Remove the Access Panel by sliding it down and then pulling the bottom of it away from the spa. Be careful not to damage the spa shell.
Remove the end of the power cord and the GFCI from inside the spa.
1
2
7
Power Cord
with GFCI
2.Locate the drain hose inside the spa. Close the valve knob on top of the drain hose. Next, make sure that the cap is fully tightened onto the end of the drain hose.
Refer to the inset drawing. Locate the two gate valves inside the spaÑthere is one gate valve on each side of the access opening. Make sure that the gate valves are open.
Refer to step 1 above.
(2)to the spa with the four #6 x 1 1/4Ó Wood Screws
Make sure that the two collars on the heater and the two collars on the pump are tightened.
2 |
|
| |
Collars |
|
| |
Gate Valve |
| Collars | |
|
| ||
Cap | Valve | Drain | |
Knob | Hose | ||
|
8