Panasonic EP-MA10 manual Setting UP the Massage Lounger, Where to use the unit

SETTING UP THE MASSAGE LOUNGER

English

1.Where to use the unit

•Ensure there is adequate space to recline.

•Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources, because this can cause discoloration or hardening of the synthetic leather.

•Place the unit on a mat to prevent floor damage.

•When placing a mat under the unit, the size of the mat should be sufficient [at least 47.2 in. × 27.6 in. (120 cm × 70 cm)] to cover the areas where the unit touches and where the legrest could touch the floor, as shown in the diagram on the right.

•Install the unit near a power outlet.

See Warning No. 11 and 12 on page 1.

Keep at least 4" (10 cm) away from the wall.

Approx. 71.3 in. (181 cm)
Width approx.	Approx.
32.3 in. (82 cm)	12.6 in. (32 cm)
Approx.
9.8 in. (25 cm)
Mat

Area where	legrest	Area	where unit
could touch the floor		touches the floor

2.Removing everything from the box and installing the unit

•Since the unit is very heavy [approximately 144 lbs (65 kg)], be careful to avoid back injuries. (The unit must be carried by two persons.)

•When using the wheels to move the unit, place a mat

			on the floor to protect the floor surface.
			To put the unit down on the floor
Fabric			• Put the unit down slowly and carefully watch your step.
			• Put down the legrest by holding it with your hands until
Section		Groove	it has been set on the floor completely. If you release
	Place your		your hands before the legrest is fully extended, the
Hold the cloth			legrest will forcefully return to the initial position.
	fingers in the
section on the	groove
backside

Legrest Back cover Mat