Ryobi Outdoor RPT2543C, RY7011 manual Silencer Guard Assembly

Page 8

SILENCER GUARD ASSEMBLY

1.Remove silencer guard and two screws from the owner’s kit.

2.Attach the silencer guard to the rear housing.

NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.

3.Using the torque wrench supplied, install the two screws and tighten securely.

REAR HOUSING

TORQUE

WRENCH

SCREWS

SILENCER

GUARD

BENT END OF

SILENCER GUARD

OPENING IN REAR

HOUSING

Fig. 4

Image 8

Contents OPERATOR’S Manual Table of Contents SafetySpecific Safety Rules for Trimmer USE Symbols Symbol Name ExplanationTechnical Data 13.3Features UnpackingInstructions Packing List for OWNER’S KITSee Figure AssemblyAssembly Instructions Silencer Guard Assembly Operating the Trimmer OperationFuel and Refuelling Advancing String Using the EZ Line TAP Advance System Advancing the StringCutting Tips Grass Deflector Line Trimming CUT-OFF BladeStarting and Stopping To Start a Cold EngineTo Start a Warm Engine To Stop the EngineMaintenance Spool Replacement EZ Line TAP Advance SystemNEW PRE-WOUND Spool See Figures 10Cleaning the Exhaust Port and Silencer String ReplacementSpark Arrester Arrows on Spool Anchor Hole First StringReplacing and Cleaning AIR Filter Fuel CAPSparking Plug Storage 1 Month or LongerTroubleshooting Dealer. See FigureIdle Speed Screw LO Needle High Needle Warranty Safety DirectiveGuarantee Statement Rtsa / Rtuk / RTG Sound Pressure Sound Power Vibration Model Model noRyobi Technologies GmbH