Ryobi Outdoor PBC3046B Assembly, See Figure, Throttle Trigger TOP Clamp Handle BAR Bottom

Page 7

ASSEMBLY

1.Place the handlebar in the bottom clamp located on the shaft housing.

NOTE: The throttle trigger must be mounted to the operator’s right side.

2.Insert the square tab of top clamp into the mounting hole of the bottom clamp.

3.Adjust the handlebar for best operator control in a comfortable upright position.

4.Install the knob and tighten securely.

BOTTOM CLAMP

CLAMP

TOP CLAMP

Fig. 2

Image 7

Contents OPERATOR’S Manual Safety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsSymbol Name Technical DataPacking List for OWNER’S KIT FeaturesUnpacking InstructionsThrottle Trigger TOP Clamp Handle BAR Bottom AssemblyHandle See FigureGrass Deflector and Blade Guard USE Silencer Guard AssemblyBent END Silencer Guard Opening in Rear Housing Attaching the Shoulder StrapGrass Deflector Blade GuardConverting from Trimmer to Brushcutter Removing the Blade Installing the BladeInstalling the String Head Converting from Brushcutter to TrimmerFuel and Refuelling OperationOperating the Trimmer Cutting Tips Advancing the StringGrass Deflector Line Trimming CUT- OFF Blade TRI-ARC Blade Operating the BrushcutterCutting Technique Blade To Start a Warm Engine Starting and StoppingSee Figures 14 To Start a Cold EngineSee Figures 16 MaintenanceSpool Replacement EZ Line TAP Advance System NEW PRE-WOUND SpoolBlade Protector See Figures 23 Cleaning the Exhaust Port and SilencerReplacing and Cleaning AIR Filter Spark ArresterSparking Plug Fuel CAPStorage 1 Month or Longer Idle speed. See Figure TroubleshootingIdle Speed Screw Needle EC Declaration of Conformity WarrantySafety Directive Guarantee Statement Rtsa / Rtuk / RTGRyobi Technologies GmbH