Ryobi Outdoor RY70107A, PBC3046B manual Attaching the Shoulder Strap, Silencer Guard Assembly

Page 8

ASSEMBLY

ATTACHING THE SHOULDER STRAP

See Figure 3.

1.Connect the latch on the shoulder strap to the strap hanger.

2.Adjust the strap to a comfortable position.

NOTE: To quickly release the product from the shoulder strap, sharply pull the quick release tab.

SHOULDER

REAR HOUSING

TORQUE

WRENCH

SCREWS

SILENCER

GUARD

QUICK

STRAP

RELEASE

TAB

LATCH

STRAP HANGER

Fig. 3

SILENCER GUARD ASSEMBLY

See Figure 4.

1.Remove silencer guard and two screws from the owner’s kit.

2.Attach the silencer guard to the rear housing.

NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.

3.Using the torque wrench supplied, install the two screws and tighten securely.

BENT END OF

SILENCER GUARD

OPENING IN REAR

HOUSING

Fig. 4

GRASS DEFLECTOR AND BLADE GUARD USE

NOTE: When converting from brushcutter to trimmer, or trimmer to brushcutter, make sure the correct guard/ deflector is being used. See Figure 5.

GRASS DEFLECTOR FOR

TRIMMER USE

BLADE GUARD FOR BRUSHCUTTER USE

Fig. 5

8

Image 8

Contents OPERATOR’S Manual Table of Contents SafetySpecific Safety Rules for Trimmer USE Specific Safety Rules for Brushcutter and Blade USESymbols Symbol Name ExplanationTechnical Data Symbol NameFeatures UnpackingInstructions Packing List for OWNER’S KITAssembly HandleSee Figure Throttle Trigger TOP Clamp Handle BAR BottomSilencer Guard Assembly Bent END Silencer Guard Opening in Rear HousingAttaching the Shoulder Strap Grass Deflector and Blade Guard USEConverting from Trimmer to Brushcutter Blade GuardGrass Deflector Installing the Blade Installing the String HeadConverting from Brushcutter to Trimmer Removing the BladeOperating the Trimmer OperationFuel and Refuelling Grass Deflector Line Trimming CUT- OFF Blade Advancing the StringCutting Tips Cutting Technique Blade Operating the BrushcutterTRI-ARC Blade Starting and Stopping See Figures 14To Start a Cold Engine To Start a Warm EngineMaintenance Spool Replacement EZ Line TAP Advance SystemNEW PRE-WOUND Spool See Figures 16Blade Protector Cleaning the Exhaust Port and Silencer Replacing and Cleaning AIR FilterSpark Arrester See Figures 23Storage 1 Month or Longer Fuel CAPSparking Plug Troubleshooting Idle speed. See FigureIdle Speed Screw Needle Warranty Safety DirectiveGuarantee Statement Rtsa / Rtuk / RTG EC Declaration of ConformityRyobi Technologies GmbH