Ryobi 410r manual Troubleshooting, U S E T I O N

TROUBLESHOOTING

ENGINE WILL NOT START

C A U S E	A C T I O N
On/Off Stop Control in the STOP position	Turn the On/Off Stop Control to START
Empty fuel tank	Fill fuel tank
Primer bulb wasn't pressed enough	Press primer bulb fully and slowly 5-7 times
Engine flooded	Use starting procedure with choke control in the
	RUN position, Pg. 12
Old or improperly mixed fuel	Drain fuel tank / Add fresh fuel mixture
Fouled spark plug	Replace or clean the spark plug

ENGINE WILL NOT IDLE

C A U S E	A C T I O N
Air Filter is Plugged	Replace or clean the air filter
Old or improperly mixed fuel	Drain fuel tank / Add fresh fuel mixture
Improper carburetor adjustment	Adjust per instruction Pg. 16

ENGINE WILL NOT ACCELERATE

C A U S E	A C T I O N
Old or improperly mixed fuel	Drain fuel tank / Add fresh fuel mixture
Improper carburetor adjustment	Take to an authorized service dealer for
	carburetor adjustment

ENGINE LACKS POWER OR STALLS WHEN UNDER LOAD

C A U S E	A C T I O N
Old or improperly mixed fuel	Drain fuel tank / Add fresh fuel mixture
Improper carburetor adjustment	Take to an authorized service dealer for
	carburetor adjustment
Cultivator tines bound with dirt or grass	Stop the unit, switch the On/Off Stop Control to
	STOP, clean and remove any debris binding the tines

18