Ryobi 410r Assembly Instructions, Assembling the Unit, Installing the Wheel Bracket Assembly

Page 8

ASSEMBLY INSTRUCTIONS

ASSEMBLING THE UNIT

Your yard and garden cultivator has been completely assembled except for the handlebar, throttle cable and wheel bracket assembly. A large phillips screwdriver is needed for assembly.

Unpacking

1.Carefully unpack the contents and insure that nothing is damaged. Unwrap the throttle cable without bending or kinking it.

WARNING: Do not cut the plastic strap off the handle bar. The strap is under tension and can cause serious personal injury if cut.

2.Squeeze the handle bar and slide the plastic strap down and off (Fig. 1).

NOTE: Do not squeeze the handlebar too tight. Excessive squeezing can cause the handlebar to kink.

Squeeze

Together

Plastic

Strap

INSTALLING THE WHEEL BRACKET ASSEMBLY

WARNING: To avoid injury from the tines, wear heavy gloves and a long sleeve shirt when installing the wheel bracket assembly.

1.With the unit on it’s side, place the wheel bracket assembly on the underside of the tine guard (Fig. 2).

2.Install a carriage bolt through each of the slotted holes in the wheel bracket and into the tine guard.

3.On the top side of the tine guard, install a lock washer and a wing nut onto each of the bolts (Fig. 2).

4.Make sure the square shoulder of the bolts are through the slotted holes in the wheel bracket. Tighten the wing nuts (Fig. 3).

NOTE: Do not over tighten the wing nuts. Loosening the wing nuts allow the wheel height to be adjusted.

Tine

 

Guard

Wheel

 

Bracket

 

Assembly

Wing Nut &

Lock Washer

Fig. 2

Fig. 1

Fig. 3

8

Image 8
Contents OPERATOR’S Manual Table of Contents IntroductionArrestor Kit California Emission RegulationsSpark Arrestor Symbol Meaning Rules for Safe OperationFor Service INFORMATION, Call Safety and International SymbolsSymbolmeaning Safety Alert Symbol Unleaded Fuel OILThrown Objects can Cause Severe Injury ON/OFF Stop Control HOT Surface WarningKnow Your Unit ApplicationAssembly Instructions Installing the Wheel Bracket AssemblyAssembling the Unit UnpackingInstalling the Handlebar Throttle Cable Assembly Filling the Fuel Tank OIL and Fuel InformationOIL and Fuel Mixing Instructions Stopping Instructions STARTING/STOPPING InstructionsStarting Instructions Operating Tips Adjusting Tine DepthOperating Instructions Maintenance and Repair Instructions Maintenance ScheduleFrequency Maintenance Required Refer to Tine Removal and ReplacementCleaning the Air Filter Reinstalling the Air filter/Muffler CoverCarburetor Setting Replacing the Spark PlugCleaning and Storage Cleaning the UnitACCESSORIES/REPLACEMENT Parts StorageTroubleshooting U S E T I O NSpecifications EnginePage Owners Warranty Responsibilities Manufacturers Warranty CoverageLimited TWO-YEAR Warranty REV. B