ASSEMBLY
WARNING:
Disconnect the spark plug wire before assembling parts. Failure to do so could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figures 2 - 4.
��n Assemble the elbow tube onto blower by aligning raised locking tabs on blower unit with the raised locking slots on elbow as shown and twist to secure.
nAttach bellows onto elbow tube by aligning raised lock- ing tabs on elbow tube with the raised locking slots on bellows and twist to secure.
nAttach throttle control handle tube onto bellows by aligning raised locking tabs on bellows with the raised locking slots on throttle control handle tube and twist to secure.
NOTE: The position of the throttle control handle may be adjusted for the best comfort after the blower is strapped onto the operator’s back.
nJoin the straight upper tube and nozzle together by align- ing raised locking tabs on straight upper tube with the raised locking slots on nozzle and twist to secure.
nAssemble the connected lower tubes to the throttle control handle tube by aligning raised locking tabs on the throttle control handle tube with the raised locking slots on connected lower tubes by twisting to secure.
NOTE: Check all locking connections after initial run to ensure they are tightly secured.
nHold the throttle cable against the bellows and install the cable ties. Cable ties should be tight enough to retain the throttle cable to the bellows but still allow for move- ment.
ELBOW
TUBE
BELLOWS
THROTTLE |
|
CONTROL |
|
HANDLE TUBE |
|
(UPPER TUBE) | Fig. 2 |
|
THROTTLE CONTROL
HANDLE TUBE
(UPPER TUBE)
NOZZLE
UPPER TUBE
Fig. 3
THROTTLE
CONTROL
HANDLE TUBE (UPPER TUBE)
THROTTLE
CABLE
CABLE TIE
Fig. 4
9