Ryobi Outdoor RY08570 manual Operating the Blower, Proper Operating Position, Throttle Trigger

Page 12

OPERATION

WARNING

Keep away from all hot surfaces of the blower. Failure to do so could result in possible serious personal injury.

OPERATING THE BLOWER

See Figure 8.

nStart the blower. Refer to “Starting and Stopping” earlier in this manual. Slip arm through harness strap and onto shoulder, then repeat for the other shoulder. Adjust the straps to a comfortable position. Refer to “Adjusting Har- ness Straps” earlier in this manual. Operate the blower from the right side as shown in illustration.

nTo keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile.

nTo reduce sound levels, limit the number of pieces of equipment used at any one time.

nOperate blower at the lowest possible throttle speed to do the job.

nCheck your equipment before operation, especially the muffler, air intakes and air filters.

nUse rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when water is available.

nConserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches and gardens.

nWatch out for children, pets, open windows or freshly washed cars, and blow debris safely away.

nUse the nozzle for larger volume, so the air stream can work close to the ground.

nAfter using blowers or other equipment, CLEAN UP! Dispose of debris properly.

CRUISE CONTROL / THROTTLE LOCK

The Cruise Control (throttle lock) can be used to operate the blower without holding the throttle trigger.

To engage the cruise control / throttle lock: See Figure 9.

nPull cruise control lever back toward user, and stop at the desired throttle setting.

nTo release the cruise control, push cruise control lever all the way toward the front of unit.

PROPER OPERATING POSITION

Fig. 8

CRUISE CONTROL (THROTTLE LOCK)

THROTTLE TRIGGER

Fig. 9

12

Image 12
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules ServiceSpecific Safety Rules RefuelingSymbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Product Specifications AdjustmentsHarness Height Waist Harness BellowsFeatures AssemblyAssembling the Blower Tubes Elbow Tube BellowsThrottle Control Handle Tube Upper Tube Nozzle Throttle Cable Cable TIEAdjusting Harness and Waist Straps Adjusting Throttle Control HandleOperation Mixing the FuelEngine Switch Filling the TankStarting and Stopping Choke Chokelever LeverOperating the Blower To engage the cruise control / throttle lock See FigureProper Operating Position Throttle TriggerMaintenance General MaintenanceReplacing and Cleaning AIR Filter To clean the air filterCleaning the Exhaust Port and Muffler Spark ArrestorFuel CAP Spark PlugAccessories TroubleshootingAccessories Warranty Limited Warranty StatementMANUFACTURER’S Warranty Coverage OWNER’S Warranty ResponsibilitiesMaintenance Requirements CoverageThis Product WAS Manufactured with a Catalyst Muffler Page Service Model NO. and Serial no California Proposition