Porter-Cable PCK4040SP, D26221-025-1 Starting, To Shut Down, Turn water source on. Note Make

Page 12
High Pressure Hose

STARTING

Prior to starting, refer to your engine manual for proper starting procedures for your engine type.

1.In a well ventilated outdoor area Add fresh high quality unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to engine manual for correct procedure.

2.Check engine oil level. See Engine Operators Manual for correct procedure.

NOTE: There will be a slight amount of oil in the engine from factory testing.

3.Verify the filter screen is in water inlet of pump. NOTE:

Cone side faces out.

Filter Screen

4.Connect water source to pump inlet.

NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.

5.Connect high pressure hose to pump outlet.

6.If applying a chemical or cleaning solution, see How To Siphon Chemicals/Cleaning Solvents

in Operation section of this manual.

7. Turn water source on. NOTE: Make

sure water supply is turned on.

8. Start engine. See Engine operators Manual for correct procedure. NOTE: If the engine does not start after two pulls, pull the trigger to relieve the pressure.

9. Depress trigger on gun to start water

Water

 

flow. NOTE: Stand on a stable surface

Source

 

and grip gun/wand firmly with both

 

 

 

 

 

 

hands. Expect the gun to kick when triggered.

 

 

10.Release trigger to stop water flow.

11.Adjust nozzle spray for the task being performed or change quick connect tip. See How To Use Wand instructions in this section.

TO SHUT DOWN

IMPORTANT: Read and understand how to shut down the pressure washer before operating.

1.If you have siphoned chemicals, siphon a bucket of clean water through the chemical hose. NOTE: Failure to do so will cause damage to the pump.

2.Refer to engine manual for correct engine shut down procedure.

NOTE: NEVER turn the water off with the engine running.

3.Turn water source off.

4.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

5.See Storage section in this manual for proper storage procedures.

D26221

12- ENG

Image 12
Contents Horsepower 4000 PSI GPM Pressure Washer PCK4040SPGeneral Information Safety Guidelines / Definitions Important Safety InstructionsHazard What can Happen Risk Unsafe Operation BOX Contents Assembly Operation Basic Elements of EnginePressure Washer Throttle Control Lever Controls engine speedHOW to USE To Adjust PressurePressure Washer Terminology To USE Wand To Siphon CHEMICALS/CLEANING Solvents Read and Understand ALL Warnings Before Starting UnitPress chemical hose onto barbed fitting Starting To Shut DownTurn water source on. Note Make Depress trigger on gun to start waterMaintenance How To Change Pump OilEngine PumpHOW to Clean the Water Inlet Filter WandStorage Engine PumpWindshield washer fluid may also be used Troubleshooting Guide ProblemCausecorrection Cause CorrectionLimited Warranty Responsibility of Original Purchaser initial UserENG D26221 Quick Facts Call