Porter-Cable D25804-025-1 Starting, To Shut Down, Turn water source on. Note Make sure water

Page 12

TO SHUT DOWN

IMPORTANT: Read and understand how to shut down the pressure washer before operating.

1.If you have siphoned chemicals, siphon a bucket of clean water through the chemical hose. NOTE: Failure to do so will cause damage to the pump.

2.Refer to engine manual for correct engine shut down procedure.

NOTE: NEVER turn the water off with the engine running.

3.Turn water source off.

4.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.

5.See Storage section in this manual for proper storage procedures.

STARTING

Prior to starting, refer to your engine manual for proper starting procedures for your engine type.

1.In a well ventilated outdoor area Add fresh high quality unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to engine manual for correct procedure.

2.Check engine oil level. See Engine Operators Manual for correct procedure.

NOTE: There will be a slight amount of oil in the engine from factory testing.

3.Verify the filter screen is in water inlet of pump. NOTE:

Cone side faces out.

Filter Screen

 

4.Connect water source to pump inlet.

NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.

5.Connect high pressure hose to pump outlet.

6.If applying a chemical or cleaning solution, see How To Siphon Chemicals/Cleaning Solvents in Operation

 

section of this manual.

 

 

High

7.

Turn water source on. NOTE: Make sure water

Pressure

 

supply is turned on.

Hose

 

 

8.

Start engine. See Engine operators Manual for

 

 

correct procedure. NOTE: If the engine does not

 

 

start after two pulls, pull the trigger to relieve the

 

 

pressure.

 

9.Depress trigger on gun to start water flow. NOTE: Water Stand on a stable surface and grip gun/wand firmly Source with both hands. Expect the gun to kick when triggered.

10.Release trigger to stop water flow.

11.Adjust nozzle spray for the task being performed or change quick connect tip. See How To Use Wand instructions in this section.

D25804

12- ENG

Image 12
Contents Instruction General Information Safety Guidelines / Definitions Important Safety InstructionsHazard What can Happen Light or unsecured objects can become hazardous projectiles BOX Contents Assembly Operation Pressure WasherHOW to USE To Adjust PressureBasic Elements of Engine Pressure Washer TerminologyTo USE Wand To Siphon CHEMICALS/CLEANING Solvents Read and Understand ALL Warnings Before Starting UnitPress chemical hose onto barbed fitting located Starting To Shut DownTurn water source on. Note Make sure water Maintenance EnginePump HOW to Clean the Water Inlet Filter WandReconnect spark plug wire StorageEngine Pump Windshield washer fluid may also be usedTrouble Shooting Guide ProblemCausecorrection Problem Cause Correction ChemicalsLimited Warranty Responsibility of Original Purchaser initial UserENG D25804 Quick Facts Call