Lower Shoulder Strap Clamp, Blade, Locking Lever

LOWER SHOULDER STRAP

CLAMP

Spacer Tabs

Spacer Tabs positioned for use on 1∀ diameter upper tube

1.Place the upper shoulder strap clamp over the upper tube above the handlebar.

2.Position the lower shoulder strap clamp under the upper tube and align the upper and lower clamp screw holes (use spacer tabs between upper and lower clamps if necessary to secure clamp, i.e. for 1∀ diameter upper tube).

Upper Shoulder

Strap Clamp

POWERHEAD

END

				ATTACHMENT
	Lower Shoulder			ATTACHMENT
	Lower Shoulder			END
	Strap Clamp			END
	Strap Clamp			Screws
				Screws

3.Insert two screws into the screw holes.

4.Secure shoulder strap clamp by tighten- ing screws with the hex wrench.

5.Try on shoulder strap and adjust for fit and balance before starting the engine or begin- ning a cutting operation.

6.Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.

NOTE: A one-half twist is built in the shoulder strap to allow the strap to rest flat on the shoul- der.

7.Adjust the strap, allowing the hook to be about 6 inches below the waist.

8.Fasten the strap hook to the upper clamp and lift the tool to the operating position.

Shoulder Strap

Shoulder

Strap

Clamp

KNOW YOUR BRUSHCUTTER ATTACHMENT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.

Locking Lever

Hanger	Tube


		Gearbox

							Blade
Blade Shield							Blade
Blade Shield

BLADE

The BLADE is designed for cutting grass, weeds, and brush up to 1/2 inch in diameter.

LOCKING LEVER

The LOCKING LEVER is used to prevent the blade shaft from turning during blade replace- ment.