Poulan 20112X92E1, 20112X92E0 Assemble Wheels, Assemble Upper Handle, Assemble Upstop Bracket

Page 7

1.Position lower handle on housing so cut-off flat is forward as shown.

2.Align holes in handle with holes in housing as shown and assemble 3/8- 16 x 3/4 hex bolts, flat washers, and locknuts. Tighten securely.

3.Repeat for opposite side of mower.

Flat washers

Locknuts

Lower handle

Hex bolts

ASSEMBLE WHEELS

Cutting height is determined by assem- bling the wheels in one of four possible positions on the mower housing. All wheels must be in the same height posi- tion for even cutting.

1.For each wheel, assemble shoulder bolt and spacer as shown.

2.Assemble 1-1/4" diameter washers (rear wheels only) and 3/8-16 locknuts on inside of mower housing and tighten securely.

1-1/4" diameter Washer (Rear wheels only)

Mower housing

Cut-off flat forward

ASSEMBLE UPPER HANDLE

1. Position upper handle over lower

handle with small hole for mounting

up-stop bracket to right side and as-

semble 1/4-20 x 1-1/2 hex bolts and

Shoulder bolt

Spacer

3/8-16 Wheel Locknut

1/4-20 locknuts. Tighten securely.

ASSEMBLE UPSTOP BRACKET

2.Position upstop bracket on the right inside of upper handle as shown.

3.Install the hex washer head screw into the hole in up-stop bracket and upper handle. Tighten securely.

AS VIEWED FROM FRONT OF MOWER

Up-stop bracket

Hex bolts

Hex washer head screw

Lock nuts

ASSEMBLE DISCHARGE GUARD

1.Place discharge guard on top of lawn mower discharge opening.

2.Install two (2) 1/4-20 x 3/4 hex bolts through housing and discharge guard.

3.Install two (2) 3/4" diameter washers and two (2) 1/4-20 locknuts. Tighten securely.

Locknuts

Washers

Discharge guard

Hex bolts

7

Image 7
Contents Product Information Mower ModelsWarranty Table of ContentsOwners Information Safety RulesGeneral Operation IV. Safe Handling of Gasoline General ServiceII. Slope Operation III. ChildrenParts Bag contents shown full size Product SpecificationsTools Required for Assembly Assembly / PRE-OPERATIONUnpack Carton Assemble Discharge Guard Assemble WheelsAssemble Upper Handle Assemble Upstop BracketSpark Plug Wire Install Control BARInstall Starter Rope Assemble Spark Plug Boot toOperation Meets Cpsc Safety RequirementsKnow Your Lawn Mower Before Starting Engine HOW to USE Your Lawn MowerTo Start Engine To Stop EngineMowing Tips Lubrication MaintenanceGeneral Recommendations Lubrication Chart Before Each USEBlade Care Lawn MowerEngine TiresSpark Plug CleaningAIR Filter MufflerStorage Service and AdjustmentsCylinder Problem Cause CorrectionOther Engine OILPoor cut Parts and Service