INSTALL CONTROL BAR
1.Position control bar so flattened sec- tion with hole is on opposite side of handle as
2.Insert one end of control bar into handle hole on inside of handle. Care- fully push in on opposite end of control bar and insert into hole on opposite side of handle.
Upper | Control bar |
handle |
|
Engine zone control cable
INSTALL STARTER ROPE
Control bar
ASSEMBLE ENGINE ZONE CONTROL CABLE TO ENGINE
Cable attaches under the brake arm cover, which is opposite the spark plug end of engine.
1.Straighten cable and find the end with the small plastic fitting.
2.Hook the “Z” bend fitting on inner wire of cable into hole in brake arm of engine.
3.Align the tapered end of the small plastic fitting with hole in the mounting bracket and push in until fitting snaps into place.
“Z” bend cable fitting
Brake arm
1.Put threaded end of rope guide through hole in side of upper handle above lower handle crossbar. Secure with
2.Hold control bar against upper handle and slowly pull engine starter rope out until rope will slip into loop of rope guide.
Upper handle 
Rope
guideLocknut
Lower handle crossbar
Engine starter rope
Small |
| ASSEMBLE SPARK PLUG BOOT TO | |
| SPARK PLUG WIRE | ||
plastic | Mounting | ||
1. Remove spark plug wire from spark | |||
fitting | bracket | ||
|
| plug and install boot to wire. | |
ASSEMBLE ENGINE ZONE CONTROL | 2. Reconnect spark plug wire to spark | ||
plug. | |||
CABLE TO UPPER HANDLE |
| ||
| Spark | ||
Assemble cable to opposite side of up- | |||
plug | |||
stop bracket. |
| wire | |
1.Route cable below crossbar of lower handle and up to control bar.
2. | Hook “Z” bend fitting on inner wire into |
|
|
| hole in control bar. |
|
|
3. | Attach cable fitting to upper handle as |
|
|
| shown. |
|
|
4. | Secure cable to lower handle with wire |
|
|
| ties. | 8 | Boot |