Poulan 9601210000, 430673 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 23

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PO17542LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Reverse Operation System ROSTo Operate on Hills To TransportTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceBlade Removal See Fig BatteryTractor Blade CareLubrication Transaxle MaintenanceEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Excessive Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty

9601210000, 430673 specifications

The Poulan 430673, also known by its part number 9601210000, is a noteworthy product in the outdoor power equipment market, specifically designed for lawn care enthusiasts and landscaping professionals alike. Known for its durability and efficient performance, this model has gained a reputation for reliability over the years.

One of the main features of the Poulan 430673 is its powerful engine, which boasts a robust output ideal for tackling tougher lawn maintenance tasks. With adequate horsepower, users can confidently manage a variety of yard sizes and grass types without experiencing a drop in performance. The unit is designed to provide consistent power, ensuring efficient operation during extended use.

Furthermore, the Poulan 430673 incorporates advanced technology that enhances user experience and overall performance. The engine features a patented starting mechanism, often characterized by an easy-start function, allowing users to quickly start the machine without the frustration that comes with traditional recoil starters. This feature especially appeals to those who may not have extensive experience with outdoor power tools.

The ergonomic design of the Poulan 430673 reflects an understanding of user comfort and ease of handling. It is equipped with a comfortable grip and lightweight structure, minimizing strain during operation. This practicality makes it easier for users to navigate around complex garden layouts or longer work sessions without physical fatigue.

In terms of safety, the Poulan 430673 also comes equipped with several features aimed at protecting the user. A safety switch prevents accidental startups, providing peace of mind when transporting or storing the unit. The design actively promotes safe operation, encouraging users to adhere to necessary precautions while maintaining their yards.

Additionally, this model stands out due to its compatibility with various attachments and accessories. This versatility allows users to customize their experience based on specific yard needs, whether it's clearing debris, edging, or mulching. The adaptability of the Poulan 430673 makes it not just a single-purpose tool, but a multifaceted piece of equipment that can grow with the user’s gardening or landscaping projects.

In conclusion, the Poulan 430673, with its powerful engine, user-friendly features, ergonomic design, safety measures, and compatibility with various attachments, serves as an excellent choice for individuals seeking reliable outdoor power equipment. It embodies a perfect blend of technology and practicality, making it a favored option among both casual gardeners and serious landscapers.
Top Page Image Contents