Poulan 96042003500 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

Depress clutch/brake pedal fully and set parking brake.

Place gearshift lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Place attachment clutch in “DISENGAGED” position.

Lower attachment lift lever to its lowest position.

Roll belt off engine pulley (M) and belt keepers (G).

Remove retainer spring (K), slide collar (L) off and push housing guide (P) out of bracket.

Remove clutch cable spring (Q) from idler arm (R).

Disconnect front link (E) from mower - remove retainer spring and washer.

Go to either side of mower and disconnect mower suspension arm (A) from chassis pin (B) and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

CAUTION: AFTER REAR LIFT LINKS

ARE DISCONNECTED, THE ATTACH-

MENT LIFT LEVER WILL BE SPRING

LOADED. HAVE A TIGHT GRIP ON LIFT

LEVER WHEN CHANGING POSITION

OF THE LEVER.

Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE

MOWER IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS

(C)FROM TRACTOR AND HOOK THE CLUTCH SPRING

(Q)INTO THE CABLE GUIDE ON FRONT EDGE OF LOWER DASH.

TO INSTALL MOWER (See Fig. 16–19)

Be sure tractor is on level surface and engage parking brake.

Lower attachment lift lever to it's lowest position.

CAUTION: LIFT LEVER IS SPRING

LOADED. HAVE A TIGHT GRIP ON

LIFT LEVER, LOWER IT SLOWLY AND

ENGAGE IN LOWEST POSITION.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

Slide mower under tractor until it is centered under tractor.

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

Repeat on opposite side of tractor.

G M F

Q RG

A E

B

P C

K

L D

FIG. 15

19

Image 19
Contents PB19546LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Contents of Hardware Pack Carton AssemblyTools Required for Assembly To Remove Tractor fromCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate Mower See Fig Before Starting the Engine Mowing Tips General Recommendations MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Transaxle Cooling BatteryEngine BeltsCleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Precision SIDE-TO-SIDE AdjustmentTo Replace Motion Belt Drive See Fig Belt InstallationTo Replace Mower Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Wheels and Tires Tractor - Model Number PB19546LT 96042003500, Product no 42KEY Part Description Fuse SchematicElectrical 175242 Chassis 194263 Drawbar 162 DriveRepair Parts Engine Steering Seat Mower Lift Mower Deck Repair Parts Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty Policy

960 42 00-35, 96042003500 specifications

The Poulan 96042003500, also known as the Poulan Pro 42cc 2-Cycle Gas Chainsaw, is a reliable and efficient tool designed for both professional landscapers and homeowners alike. This chainsaw stands out in a competitive market due to its blend of power, user-friendly features, and advanced technologies that enhance performance and comfort during operation.

One of the primary features of the Poulan 96042003500 is its powerful 42cc engine. This robust engine is designed to deliver exceptional performance, providing enough power to tackle a variety of cutting tasks, from tree trimming to felling larger trees. The 2-cycle engine is known for its efficiency, ensuring users can perform their tasks with minimal downtime.

The chainsaw is equipped with a 16-inch bar and chain, making it suitable for a wide range of applications. This size strikes a balance, allowing users to handle both small and medium-sized jobs without compromising maneuverability. The chain itself is designed for rapid cutting, contributing to the overall efficiency of the tool.

User comfort and safety have been prioritized in the design of the Poulan 96042003500. It features an ergonomic handle that provides a comfortable grip, reducing fatigue during extended use. Additionally, the chainsaw is equipped with a chain brake for enhanced safety, which stops the chain immediately in case of kickback, protecting the user from potential injuries.

The chainsaw also incorporates advanced technologies like an automatic oiling system, which ensures that the chain and bar remain adequately lubricated during operation. This feature not only extends the life of the saw but also reduces maintenance requirements. The easy-access air filter makes maintenance straightforward, allowing users to clean or replace the filter quickly, promoting better engine performance.

In summary, the Poulan 96042003500 is a versatile and powerful chainsaw that combines robust performance with user-friendly features. Its 42cc engine, lightweight design, and safety features make it an excellent choice for anyone looking to take on outdoor tasks effectively. Whether you're cutting firewood or shaping your landscape, this chainsaw stands as a reliable companion, offering the performance and comfort required for a successful job.