Poulan 532 43 88-98, 96018000400 manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

OF MOWER TO

 

OF MOWER TO

GROUND

 

GROUND

A

GROUND LINE

A

Fig. 15

SUSPENSION ARM

LIFT LINK

ADJUSTMENT NUT

Fig. 16

FRONT-TO-BACK ADJUSTMENT (See Figs. 17 and 18)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its high- est position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

“D”

“D”

Fig. 17

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT “F”

NUT “E”

TRUNNION

FRONT LINKS

Fig. 18

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents PO17542LT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering WheelAssembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidTo Check Battery See Fig Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsChecklist Operation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningEngine Cooling System See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigTo Check Brake Transaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionExcessive Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

96018000400, 532 43 88-98 specifications

The Poulan 532 43 88-98 (96018000400) is a versatile and robust outdoor power equipment component designed specifically for lawn care and maintenance. Recognized for its reliability, this item is an essential addition to any landscaping toolkit, ensuring that users can tackle a wide range of tasks with ease.

One of the standout features of the Poulan 532 43 88-98 model is its powerful engine. This engine is designed to handle demanding jobs effectively, providing ample power to cut through thick grass and other vegetation without bogging down. The engine's efficiency also ensures that users can accomplish more in less time, making it perfect for both residential and commercial use.

The design of the Poulan 532 43 88-98 is another aspect that sets it apart. Engineered for user comfort and control, the equipment features an ergonomic handle that reduces fatigue during extended use. Its lightweight construction makes it easy to maneuver, even in tight spaces or on uneven terrain. This blend of comfort and functionality allows for prolonged use without compromising performance.

In terms of technology, the Poulan 532 43 88-98 incorporates advanced cutting systems that ensure clean and precise cuts. The sharp blades are crafted from high-quality materials, promising durability and longevity. Additionally, the model's adjustable cutting heights provide flexibility, allowing users to customize their mowing experience based on their specific lawn care needs.

Safety is another priority with the Poulan 532 43 88-98. This model comes equipped with several safety features, including a guard that protects the user from debris and a quick-stop function that halts the blades immediately when needed. These features are especially important for reducing the risks associated with outdoor power equipment usage.

Overall, the Poulan 532 43 88-98 (96018000400) emerges as a capable solution for anyone in need of a reliable and powerful product for lawn care. Its blend of efficiency, safety, and user-friendly design makes it suitable for various settings, from traditional home lawns to professional landscaping operations. Whether you're a homeowner taking on DIY yard projects or a contractor maintaining expansive properties, the Poulan 532 43 88-98 is engineered to meet diverse lawn care demands effectively.
Top Page Image Contents