Poulan PB23H48YT To Replace Mower Blade Drive Belt See Fig, To Replace Motion Drive Belt See Fig

Page 22

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 33)

MOWER DRIVE BELT REMOVAL

Park tractor on a level surface. Engage parking brake.

Lower attachment lift lever to its lowest position.

Disengage belt tension rod (K) from lock bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a firm grip on rod and release slowly.

Remove screws (P) from mandrel covers (Q) and remove covers.

Removeanydirtorgrassclippingswhichmayhaveaccu- mulated around mandrels and entire upper deck surface.

Remove belt from electric clutch pulley (M), both man- drel pulleys (R) and all idler pulleys (V).

MOWER DRIVE BELT INSTALLATION

Install belt around all mandrel pulleys (R) and around idler pulleys (V) as shown.

Install belt onto electric clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

Reassemble mandrel covers (Q). Securely tighten all screws.

Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

Raise attachment lift lever to highest position.

P

 

Q

 

 

P

L

M

R

Q

K

 

V

 

R

 

 

R

Fig. 33

TO REPLACE MOTION DRIVE BELT (See Fig. 34)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

1.Remove mower (See “TO REMOVE MOWER” section in this manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

2.Disconnect clutch wire harness (A).

3.Remove anti-rotation link (B) on right side of tractor.

4.Removebeltfromstationaryidler(C)andclutchingidler(D).

5.Remove belt from centerspan idler (E).

6.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (F).

7.Remove belt downward from engine pulley and around electric clutch (G).

8- Slide belt toward rear of tractor, off the steering plate

(H) and remove from tractor.

BELT INSTALLATION -

1.Install new belt from tractor rear to front, over the steer- ing plate (H) and above clutch brake pedal shaft (J).

2.Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G).

3.Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pul- ley (F). Be sure belt is inside the belt keeper.

4.Install belt on centerspan idler (E).

5.Install belt through stationary idler (C) and clutching idler (D).

6.Reinstall anti-rotation link (B) on right side of tractor. Tighten securely.

7.Reconnect clutch harness (A).

8- Make sure belt is in all pulley grooves and inside all belt guides and keepers.

9. Install mower (See “TO INSTALL MOWER” section in this manual).

G

H

B A

C

J

D

E

F

02953 electric

Fig. 34

22

Image 22
Contents PB23H48YT General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigReverse Operation System ROS Service REMINDER/HOUR MeterTo Operate Mower To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningMuffler Deck Washout Port See FigTo Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig First Install ANTI-SWAY BAR S M F To Level Mower Visual SIDE-TO-SIDE Adjustment See FigPrecision SIDE-TO-SIDE Adjustment See Fig Turn nut right Turn nut left To raise mowerTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Check Brake To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Fuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionFires when turn To run when operBattery will not Engine continuesService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX ’ENTRETIEN Remarques Dépannage DE Guide Correction Cause ProblèmePuissance de Entreposage Reglages ET Revision MoteurLA DE L’ALIGNEMENT Régler Pour RossageAVANT/CAR Roues DES Convergence Fig la Voir Faible RietebatFig la Voir Tondeuse LA DE Lame Fig la Voir D’ENTRAÎNEMENTCourroie Acer Rempl Pour Freins LES Vérifier Pour LA DE Courroie LA Remplacer Pour32 .Fig Tondeuse LA Niveau LE Ajuster Pour33 .Fig 31 .Fig28 .Fig Avant l’embrayage de poulie la sur courroie la Installez29 .Fig 27 .Fig24 .FIG 26 .FIG25 .FIG 23 .FIG18 20 .Fig 21 .Fig Tondeuse LA Installer29 20 .Figs les Voir Stationnement de frein le actionnez et niveauFig La Voir Coupe DE Plateau DU Lavage DE Raccord Ligne EN Installé D’ESSENCE FiltreEntretien Silencieux’AIR Tamis LE Nettoyer ’ALLUMAGE BougieVentilation DE Système AIR À FiltrePneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementUtilisation Chaque Avant Lubrification DE TableauTransmission LA Purger Avant ET Réinstallation LA Après Purgée ÊtreUtilisation 13 .Fig’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierTracteur LE Transporter Pour Accessoires Autres ET Charrettes DES Remorquer PourROS Arrière Marche EN Fonctionnement DE Système Pentes LES Dans Utiliser PourFig la Voir J Vitesse DE Régulateur LE Utiliser Comment Tondeuse DE Lames LES Arrêter PourJauge DE Roues LES Régler Pour Tondeuse LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Embrayée Pour GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Entraînement’ACCESSOIRE D’EMBRAYAGE Interrupteur E Frein DE Pédale Montage Tionsec la Voir Rouler Faisant LE EN TE Montées NON PiécesDesmancom des fonction la et Fig la SIÈGEVoir LE Régler PourClient DU Responsabilités UtilisationMontage Produit DE SpécificationsEnfants Sécurité DE RèglesTracteurs des sécurité toute En l’utilisation pour ConseilsPentes LES Dans Fonctionnement AvertissementTracteurs des sécurité toute en l’utilisation pour Conseils Général FonctionnementCom.pro-poulan.www web site notre Visitez Avertissement