Poulan DPR22H46STA owner manual Tractor

Page 18

CUSTOMER RESPONSIBILITIES

TRACTOR

Always observe safety rules when performing any mainte- nance.

BRAKE OPERATION

If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Adjust- ments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See “PROD- UCT SPECIFICATIONS” section of this manual).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM

Be sure operator presence and interlock systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the clutch/brake pedal is fully depressed and attachement clutch control is in the disengaged position.

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

BLADE REMOVAL (See Fig. 16)

•Raise mower to highest position to allow access to blades.

•Remove hex bolt, lock washer and flat washer securing blade.

•Install new or resharpened blade with trailing edge up towards deck as shown.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

TRAILING EDGE

STAR

 

BLADE

 

CENTER

HOLE

LOCK WASHER

•Reassemble hex bolt, lock washer and flat washer in exact order as shown.

•Tighten bolt securely (27-35 Ft. Lbs. torque).

IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED.

TO SHARPEN BLADE (See Fig. 17)

NOTE: We do not recommend sharpening blade - but if you do, be sure the blade is balanced.

Care should be taken to keep the blade balanced. An unbalanced blade will cause excessive vibration and even- tual damage to mower and engine.

•The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.

•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with bal- ancer).

NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.

•Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.

CENTER HOLE

BLADE

5/8" BOLT OR PIN

FIG. 17

BATTERY

Your tractor has a battery charging system which is suffi- cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•

Remove terminal guard.

•

Disconnect BLACK battery cable first then RED

 

battery cable and remove battery from tractor.

• Rinse the battery with plain water and dry.

HEX BOLT (GRADE 8)*

MANDREL ASSEMBLY

•

Clean terminals and battery cable ends with wire brush

 

until bright.

•

Coat terminals with grease or petroleum jelly.

FLAT WASHER

*A GRADE 8 HEAT TREATED BOLT CAN BE

IDENTIFIED BY SIX LINES ON THE BOLT HEAD.

FIG. 16

• Reinstall battery (See “REPLACING BATTERY" in the

SERVICE AND ADJUSTMENTS section of this

manual).

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents DPR22H46STA Safety Rules Safe Operation Practices for Ride-On MowersSafety Rules Table of Contents Unassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig To Attach Nose Roller See FigAssemble Gauge Wheels to Mower Deck See Fig To SET UP Your Mower for Mulching See FigTo Install Mulcher Plate See Fig To Convert to Bagging or DischargingInstall Mower and Drive Belt See Figs Check for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other ATTACH- Ments Before Starting the EngineTo Operate on Hills Check Engine OIL LevelADD Gasoline To Start Engine See FigPurge Transmission Mowing Tips Mulching Mowing TipsGeneral Recommendations Lubrication ChartCustomer Responsibilities Before Each USETractor Engine Spark Plugs CleaningMuffler Engine OIL FilterTo Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See FigTo Replace Mower Drive Belt To Replace Mower Blade Drive Belt See FigTo Adjust Brake See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb Replacing Battery See FigTo Remove Hood and Grill Assembly See Fig Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Fuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionOFF Service Notes Schematic Tractor Model Number DPR22H46STAElectrical KEY Part Description Chassis and Enclosures Repair Parts Drive Repair Parts Steering Assembly KEY Part NO. NO.DESCRIPTION Engine Optional EquipmentSeat Assembly Decals Wheels & TiresMower Lift Mower Deck Repair Parts Limited Warranty Not Across Hill Only Ride UP and Down HillSighting GuideParts and Service

DPR22H46STA specifications

The Poulan DPR22H46STA is a robust and versatile riding lawn mower designed for homeowners seeking efficiency and reliability in lawn maintenance. With its 22 horsepower engine and a 46-inch cutting deck, this lawn mower is ideal for tackling medium to large yards, making it a favorite among garden enthusiasts.

One of the primary features of the Poulan DPR22H46STA is its powerful engine. The 22 HP Briggs & Stratton engine provides ample power for cutting through thick grass and uneven terrain. It offers a smooth starting mechanism, ensuring that the mower is ready to go at a moment’s notice. This engine is also designed for efficiency, delivering a balance between power and fuel economy, which is vital for homeowners looking to reduce operational costs.

The 46-inch cutting deck is another standout feature of this model. This size enables the mower to cover a significant area with each pass, reducing overall mowing time. The deck is made from durable materials, ensuring it can withstand the rigors of frequent use while ensuring a clean and precise cut. Additionally, the cutting height can be easily adjusted, giving users the flexibility to customize their mowing experience based on grass length and weather conditions.

A key characteristic of the Poulan DPR22H46STA is its ease of maneuverability. The mower features a tight turning radius, allowing users to navigate around obstacles like trees, flower beds, and fences with minimal effort. The comfortable seat is designed ergonomically, providing ample support for long mowing sessions, and is adjustable to suit different user preferences.

For enhanced cutting efficiency, the mower utilizes a dual-blade system that distributes grass clippings evenly. This feature minimizes the need for bagging, as the finely chopped clippings can act as a natural fertilizer when left on the lawn. In addition, the mower’s compatibility with optional mulch kits provides even more versatility for grass care.

The Poulan DPR22H46STA also emphasizes user-friendly controls, with an intuitive dashboard that makes it easy to monitor speed, fuel level, and engine performance. This ensures that lawn care is not only effective but also enjoyable.

In summary, the Poulan DPR22H46STA combines power, efficiency, and ease of use, making it a fantastic choice for homeowners looking to maintain their lawns effortlessly. With its reliable engine, spacious cutting deck, and user-friendly design, this riding mower stands out as a valuable addition to any yard maintenance arsenal.
Top Page Image Contents