Poulan DPR22H46STA To Replace Mower Drive Belt, To Replace Mower Blade Drive Belt See Fig

Page 22

SERVICE AND ADJUSTMENTS

FRONT-TO-BACK ADJUSTMENT (See Figs. 25 and 26)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

Before making any necessary adjustments, check that both front links are equal in length. Both links should be approximately 10-3/8".

If links are not equal in length, adjust one link to same length as other link.

To lower front of mower loosen nut “E” on both front links an equal number of turns.

When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns.

When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

Recheck side-to-side adjustment.

MANDREL

"D""D"

FIG. 25

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT "E"

NUT "F"

TRUNNION

FRONT LINKS

FIG. 26

TO REPLACE MOWER DRIVE BELT

MOWER DRIVE BELT REMOVAL (See Fig. 27) -

Park tractor on a level surface. Engage parking brake.

Remove screws from L.H. mandrel cover and remove cover.

Roll belt over the top of L.H. mandrel pulley.

Remove belt from electric clutch pulley.

Remove belt from idler pulleys.

Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface.

Check primary idler arm and two idlers to see that they rotate freely.

Be sure spring is securely hooked to primary idler arm and bolt in mower housing.

MOWER DRIVE BELT INSTALLATION (See Fig. 27) -

Install belt in both idlers. Make sure belt is in both belt keepers at the idlers as shown.

Install new belt onto electric clutch pulley.

Roll belt into upper groove of L.H. mandrel pulley.

Carefully check belt routing making sure belt is in the grooves correctly and inside belt keepers.

Reassemble L.H. mandrel cover.

 

SCREWS

ELECTRIC

 

 

 

CLUTCH

 

 

IDLER

PULLEY

L.H.

L.H.

 

PULLEYS

MOWER

MANDREL

MANDREL

DRIVE

COVER

 

 

BELT

 

 

 

PRIMARY

 

 

 

IDLER ARM

 

 

 

 

BELT

 

 

 

KEEPERS

 

 

FIG. 27

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 28)

Park the tractor on level surface. Engage parking brake.

Removemowerdrivebelt(See“TOREPLACEMOWER DRIVE BELT” in this section of this manual).

Remove mower (See “TO REMOVE MOWER” in this section of this manual).

Remove screws from R.H. mandrel cover and remove cover. Unhook spring from bolt on mower housing.

Carefully roll belt off R.H. mandrel pulley.

Remove belt from center mandrel pulley, idler pulley, and L.H. mandrel pulley.

Remove any dirt or grass which may have accumulated around mandrels and entire upper deck surface.

Check secondary idler arm and idler to see that they rotate freely.

Be sure spring is hooked in secondary idler arm and sway-bar bracket.

Install new belt in lower groove of L.H. mandrel pulley, idler pulley, and center mandrel pulley as shown.

Roll belt over R.H. mandrel pulley. Make sure belt is in all grooves properly.

Reconnect spring to bolt in mower housing and reinstall R.H. mandrel cover.

Reinstall mower to tractor (See “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual).

Reassemble mower drive belt (See “TO REPLACE MOWER DRIVE BELT” in this section of this manual).

22

Image 22
Contents DPR22H46STA Safety Rules Safe Operation Practices for Ride-On MowersSafety Rules Table of Contents Unassembled Parts HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig To Attach Nose Roller See FigAssemble Gauge Wheels to Mower Deck See Fig To SET UP Your Mower for Mulching See FigTo Install Mulcher Plate See Fig To Convert to Bagging or DischargingInstall Mower and Drive Belt See Figs Check for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other ATTACH- Ments Before Starting the EngineTo Operate on Hills Check Engine OIL LevelTo Start Engine See Fig ADD GasolinePurge Transmission Mowing Tips Mulching Mowing TipsGeneral Recommendations Lubrication ChartCustomer Responsibilities Before Each USETractor Engine Spark Plugs CleaningMuffler Engine OIL FilterTo Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See FigTo Replace Mower Drive Belt To Replace Mower Blade Drive Belt See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust Brake See FigTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb Replacing Battery See FigTo Remove Hood and Grill Assembly See Fig Interlocks and RelaysTo Adjust Choke Control See Fig To Adjust Throttle Control Cable See FigTo Adjust Carburetor Fuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionOFF Service Notes Schematic Tractor Model Number DPR22H46STAElectrical KEY Part Description Chassis and Enclosures Repair Parts Drive Repair Parts Steering Assembly KEY Part NO. NO.DESCRIPTION Engine Optional EquipmentSeat Assembly Decals Wheels & TiresMower Lift Mower Deck Repair Parts Limited Warranty Not Across Hill Only Ride UP and Down HillSighting GuideParts and Service

DPR22H46STA specifications

The Poulan DPR22H46STA is a robust and versatile riding lawn mower designed for homeowners seeking efficiency and reliability in lawn maintenance. With its 22 horsepower engine and a 46-inch cutting deck, this lawn mower is ideal for tackling medium to large yards, making it a favorite among garden enthusiasts.

One of the primary features of the Poulan DPR22H46STA is its powerful engine. The 22 HP Briggs & Stratton engine provides ample power for cutting through thick grass and uneven terrain. It offers a smooth starting mechanism, ensuring that the mower is ready to go at a moment’s notice. This engine is also designed for efficiency, delivering a balance between power and fuel economy, which is vital for homeowners looking to reduce operational costs.

The 46-inch cutting deck is another standout feature of this model. This size enables the mower to cover a significant area with each pass, reducing overall mowing time. The deck is made from durable materials, ensuring it can withstand the rigors of frequent use while ensuring a clean and precise cut. Additionally, the cutting height can be easily adjusted, giving users the flexibility to customize their mowing experience based on grass length and weather conditions.

A key characteristic of the Poulan DPR22H46STA is its ease of maneuverability. The mower features a tight turning radius, allowing users to navigate around obstacles like trees, flower beds, and fences with minimal effort. The comfortable seat is designed ergonomically, providing ample support for long mowing sessions, and is adjustable to suit different user preferences.

For enhanced cutting efficiency, the mower utilizes a dual-blade system that distributes grass clippings evenly. This feature minimizes the need for bagging, as the finely chopped clippings can act as a natural fertilizer when left on the lawn. In addition, the mower’s compatibility with optional mulch kits provides even more versatility for grass care.

The Poulan DPR22H46STA also emphasizes user-friendly controls, with an intuitive dashboard that makes it easy to monitor speed, fuel level, and engine performance. This ensures that lawn care is not only effective but also enjoyable.

In summary, the Poulan DPR22H46STA combines power, efficiency, and ease of use, making it a fantastic choice for homeowners looking to maintain their lawns effortlessly. With its reliable engine, spacious cutting deck, and user-friendly design, this riding mower stands out as a valuable addition to any yard maintenance arsenal.