Poulan PO12538LT manual Transaxle Gear Shift Lever NEUTRAL- Adjustment See Fig

Page 22

SERVICE AND ADJUSTMENTS

TRANSAXLE GEAR SHIFT LEVER NEUTRAL- ADJUSTMENT (See Fig. 21)

The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

•Make sure transaxle is in neutral (N).

NOTE: When the tractor rear wheels move freely, the transaxle is in neutral.

•Loosen adjustment bolt in front of the right rear wheel.

•Position the gear shift lever in the neutral (N) posi- tion.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

NEUTRAL

LOCK GATE

GEARSHIFT LEVER

ADJUSTMENT

BOLT

FIG. 21

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor.If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 22)

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 22

TO START ENGINE WITH A WEAK BATTERY (See Fig. 23)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

FIG. 23

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Contents of Hardware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Reverse Operation System ROSTo Operate Mower See Fig To TransportADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Maintenance General RecommendationsBlade Removal See Fig TractorTo Sharpen Blade See Fig Belts BatteryEngine Transaxle CoolingAIR Filter CleaningClean AIR Screen MufflerTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTo Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTo Adjust Brake To Check BrakeTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service
Related manuals
Manual 28 pages 56.25 Kb

PO12538LT specifications

The Poulan PO12538LT is a remarkable lawn tractor designed for homeowners seeking efficiency and reliability in maintaining their lawns. This powerful machine combines robust construction with user-friendly features that make grass cutting a breeze.

At the heart of the Poulan PO12538LT is a robust 12 HP Briggs & Stratton engine. This engine provides ample power for tackling various terrains, whether they are flat or hilly. The engine's design emphasizes longevity and ease of starting, ensuring that users can begin their lawn maintenance tasks without hassle.

One of the standout features of the PO12538LT is its 38-inch cutting deck. This size allows for efficient maneuvering in tight spaces while still providing wide cutting coverage. The cutting deck is equipped with three adjustable blades, which can easily be set to different cutting heights. This feature is essential for achieving the desired grass length, making it ideal for users who prefer a well-manicured lawn.

The tractor utilizes a foot pedal-operated transmission that enables seamless speed adjustments. Operators can effortlessly move forward or reverse without having to disengage from the cutting deck, enhancing the overall mowing experience. This allows for greater control and precision, especially around obstacles like flower beds or trees.

Comfort is a significant focus in the design of the PO12538LT. The seat is designed to provide ample support during extended mowing sessions, reducing fatigue for the operator. Additionally, the tractor incorporates a compact, ergonomic layout that ensures easy access to controls and features, promoting a user-friendly experience.

Another innovative characteristic of the Poulan PO12538LT is its maintenance-friendly design. The easy-clean cutting deck facilitates quick cleaning after mowing, and the accessible engine compartment allows for straightforward maintenance, ensuring the tractor runs efficiently for years.

Moreover, the PO12538LT features an integrated grass catcher option, enabling homeowners to collect clippings for a tidy lawn appearance. This optional accessory can be attached and detached with ease, contributing to the convenience of the tractor.

In summary, the Poulan PO12538LT lawn tractor is an excellent choice for homeowners looking to maintain their yards efficiently. With its powerful engine, adjustable cutting deck, user-friendly controls, and comfort-focused design, it proves to be both reliable and versatile. Whether you have a small suburban yard or a slightly larger plot, the PO12538LT stands ready to tackle your lawn maintenance needs with performance and ease.
Top Page Image Contents