Poulan PR17H42STC, 178219 To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

MOTION CONTROL

NEUTRAL

LEVER

LOCK GATE

 

 

ADJUSTMENT

 

BOLT

FIG. 27

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe- in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

 

WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Customer Responsibili- ties section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

POSITIVE TERMINAL

NEGATIVE TERMINAL

CHASSIS

 

 

CABLES

 

CHARGED

 

BATTERY

POSITIVE

NEGATIVE

TERMINAL

TERMINAL

FIG. 29

REPLACING BATTERY (See Figs. 30 and 31)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery

22cable and carefully remove battery from tractor.

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PR17H42STC Safety Rules Safe Operation Practices for Ride-On MowersBecome ALERT!!! Your Safety is IN- Volved Table of Contents Steering Wheel Seat Unassembled PartsSlope Sheet HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Check Deck Levelness To SET UP Your Mower for MulchingCheck Tire Pressure To Convert to Bagging or DischargingOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorTo Adjust Mower Cutting Height See Fig Stopping See Fig To USE Throttle Control See FigTo Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Mulching Mowing TipsGeneral Recommendations Lubrication ChartCustomer Responsibilities Before Each USETractor Engine Muffler CleaningSpark Plugs To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Adjust Brake See FigTransmission REMOVAL/REPLACEMENT To Replace Motion Drive Belt See FigReplacing Battery See Figs To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERInterlocks and Relays To Replace Headlight BulbTo Replace Fuse Fuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PR17H42STCElectrical 2122KEY Part Description Chassis 174619 Drive 175461 175765175578 175556Steering Assembly 175146 175121177876 175118Seat Assembly 178206 DecalsWheels and Tires 178219Spark Arrester EngineOptional Equipment 8113170551 Control Th/ch Flag 147 142 Mower Deck143 159 144 150 145 148 146 142 147 149175747 17490612175746 157109X421Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Service Notes Service Notes Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideParts and Service

178219, PR17H42STC specifications

The Poulan 178219, PR17H42STC is a powerful and versatile riding lawn mower designed to meet the needs of homeowners seeking a reliable solution for maintaining their lawns. With a robust build and innovative features, this mower stands out in the competitive market of outdoor power equipment.

One of the main features of the Poulan PR17H42STC is its 17 HP Briggs & Stratton engine, which provides ample power for cutting through thick grass and tackling uneven terrain. The engine is designed for easy starting and reliable performance, ensuring that users can depend on their mower season after season.

The 42-inch cutting deck is another highlight of this riding mower. This size allows for efficient mowing of larger grass areas while still being compact enough to maneuver around garden beds and other landscaping features. The deck is equipped with a dual-blade system, which ensures a clean and even cut, promoting a healthy lawn.

In terms of technology, the Poulan PR17H42STC features a hydrostatic transmission that offers smooth and responsive speed adjustments. This technology allows for effortless acceleration and deceleration, making it easy for users to navigate around obstacles. The mower also includes a tight turning radius, enhancing its maneuverability in tighter spaces.

Comfort and convenience are key considerations in the design of the Poulan PR17H42STC. The adjustable high back seat provides excellent support, allowing users to mow for extended periods without discomfort. The mower also features easy-access controls, including mower engagement and speed controls, which are intuitively placed for user-friendly operation.

Another notable characteristic is the durable construction of the mower. Built with high-quality materials, the Poulan PR17H42STC is designed to withstand the rigors of regular use. Additionally, the mower is equipped with reinforced cutting deck edges, extending its lifespan and ensuring it maintains its performance over time.

With its blend of power, technology, and user-friendly features, the Poulan 178219, PR17H42STC is an excellent choice for homeowners looking to efficiently care for their lawns. Its combination of performance, comfort, and durability makes it a reliable partner for all mowing tasks.
Top Page Image Contents