Poulan PR17H42STF owner manual To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

MOTION CONTROL

NEUTRAL

LEVER

LOCK GATE

 

 

ADJUSTMENT

 

BOLT

FIG. 25

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe- in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 26)

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the CUSTOMER RESPON- SIBILITIES section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

• Block up axle securely.

• Remove axle cover, retaining ring and washers to allow

wheel removal (rear wheel contains a square key - Do not

lose).

• Repair tire and reassemble.

• On rear wheels only: align grooves in rear wheel hub and

axle. Insert square key.

• Replace washers and snap retaining ring securely in

axle groove.

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

• Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 26

TO START ENGINE WITH A WEAK BATTERY (See Fig. 27)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

FIG. 27

REPLACING BATTERY (See Figs. 28 and 29)

CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PR17H42STF General Operation Safety RulesIV. Service II. Slope OperationSafety Rules Safe Operation Practices for Ride-On MowersTable of Contents Slope Sheet Unassembled PartsSteering Wheel Seat KeyHOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CAR- TONInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Deck LevelnessOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorTo Adjust Mower Cutting Height See Fig Stopping See Fig To USE Throttle Control See FigTo Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Mulching Mowing TipsCustomer Responsibilities Lubrication ChartService Dates General RecommendationsTractor Engine AIR Filter CleaningEngine Cooling Fins MufflerTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Adjust Brake See FigTransmission REMOVAL/REPLACEMENT To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Carburetor Interlocks and RelaysFuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PR17H42STF, Product Number 954 56Electrical KEY Part Description Chassis and Enclosures 158112 Keeper Belt Rear Lh Drive Repair Parts Steering Assembly KEY Part NO. NO. Description Seat Assembly Decals Wheels and TiresEngine 170551 Control Th/ch Flag Mower Deck 179748 Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Page Page Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PR17H42STF specifications

The Poulan PR17H42STF is a robust and reliable riding lawn mower designed for homeowners seeking efficiency and ease of use in lawn maintenance. With a blend of powerful performance, innovative technologies, and user-friendly features, the PR17H42STF stands out as an excellent choice for tackling medium to large-sized lawns.

At the heart of the PR17H42STF is a potent 17.5 horsepower Briggs & Stratton engine. This powerful engine ensures smooth and consistent operation, enabling the mower to handle challenging terrain and thick grass with ease. The mower’s cutting deck measures 42 inches, allowing it to cover more ground in one pass, while still being compact enough to navigate narrow spaces and tight corners. The deck is constructed from high-quality materials designed for durability and long-lasting performance.

One of the key features of the PR17H42STF is its hydrostatic transmission. This technology provides an effortless driving experience, allowing the operator to easily adjust the speed without the need for manual gear shifting. This ease of operation makes mowing a more enjoyable task, especially for those new to riding mowers.

Additionally, the PR17H42STF offers a six-position height adjustment feature, giving the user complete control over the mowing height. Whether you prefer a manicured lawn or a taller grass finish, this mower adapts to your preferences seamlessly.

For enhanced comfort and convenience, the mower is equipped with an ergonomically designed seat and user-friendly controls positioned for easy access. The steering wheel is also designed to provide a comfortable grip, further reducing fatigue during extended mowing sessions.

The Poulan PR17H42STF includes a grass collection attachment option, making it easy to gather clippings and keep your yard tidy. Furthermore, its mulching capability allows for efficient nutrient recycling back into the soil, promoting a healthier lawn.

In conclusion, the Poulan PR17H42STF is an excellent investment for homeowners looking for a reliable and robust riding mower. Its combination of powerful performance, user-friendly features, and innovative technology makes it a standout choice for those serious about maintaining their outdoor spaces with minimal effort and maximum efficiency.
Top Page Image Contents