Poulan PPH20K46 manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 13)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 13

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 14)

Raisemowertohighestpositiontoallowaccesstoblades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

Remove blade bolt by turning counterclockwise.

Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT:TOENSUREPROPERASSEMBLY,CENTERHOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 14

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Keep small vent holes open.

Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

Raise seat.

Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

Rinse the battery with plain water and dry.

Clean terminals and battery cable ends with wire brush until bright.

Coat terminals with grease or petroleum jelly.

Reinstall battery (See “REPLACING BATTERY" in the SERVICEANDADJUSTMENTSsectionofthismanual).

15

Image 15
Contents Model PPH20K46II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation H E Know Your TractorStopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigTo Transport See Figs Before Starting the EngineReverse Operation System ROS To Operate on HillsAutomatic Transmission Warm UP Service REMINDER/HOUR MeterADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionRunning Lubrication Chart MaintenanceBlade Removal See Fig BatteryTractor Blade CareEngine Spark Plugs CleaningEngine OIL Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET RevisionRÉ LES Pour Roues LES Enlever Pour Fig la Voir Batterie LA ReplacerFig la Voir Tionsrapa AvantCourroie Acer Rempl Pour Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Fig la Voir26 .Fig Tondeuse LA Niveau LE Ajuster Pour28 .Fig 27 .Fig20 .Fig 24 .Fig23 .Fig 21 .FigRéglages OU Sions Fig VoirTondeuse LA Enlever Pour 19 .FigEntretien Fig La Voir Coupe DE Plateau DU Lavage DE Raccord’ALLUMAGE Bougie Sionmistrans LA DE Moteur Fluide Moteur DE D’HUILE FiltreAIR À Filtre ’AIR Tamis LE NettoyerFrein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE Tableau12 .Fig UtilisationTondre DE Conseils Transmission LA PurgerQuetimaauto Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir ’ENTRETIEN/HOROMÈTRE IndicateurMoteur LE Démarrer DE Avant 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système Jauge DE Roues LES Régler Pour Fig la Voir J Vitesse DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Tondeuse LA Utiliser PourMoteur GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourUtilisation ’EMBRAYAGE Montage Desmancom des fonction la etTionsec la Voir Rouler Faisant LE EN TE Fig la Voir Batterie LA Vérifier Montées NON PiécesTracteur Votre DE Getamon LE Pour Exigés Outils LESSommaire Client DU ResponsabilitésProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAvertissement

PPH20K46 specifications

The Poulan PPH20K46 is a robust and versatile riding lawn mower designed for homeowners with larger gardens or properties that require efficient mowing. This powerful machine features an ergonomic design and advanced technologies that make lawn care simpler and more enjoyable.

At the heart of the Poulan PPH20K46 is its 46-inch cutting deck, which allows for a wide cutting path, reducing the number of passes needed to complete the mowing task. This feature is ideal for covering large areas quickly while maintaining an even and precise cut. The cutting height can be easily adjusted, providing versatility in lawn care. Users can select from different cutting heights, ensuring optimal results whether the grass is tall or short.

Powered by a reliable 20 horsepower Briggs & Stratton engine, the PPH20K46 delivers ample power to tackle dense grass and tough terrain. The engine is designed for durability and efficiency, ensuring that you spend less time on maintenance and more time enjoying your beautifully manicured lawn. Additionally, the electric start feature adds convenience, allowing users to start the mower with the simple push of a button.

One of the standout characteristics of the Poulan PPH20K46 is its hydrostatic transmission. This technology allows for smooth and seamless operation without the need for shifting gears. Users can easily adjust their speed on the fly, making maneuvering around obstacles or tight corners a breeze. The fully adjustable seat and steering wheel offer customizable comfort, enabling users to find the perfect position for optimal control and visibility.

For those who value cleanliness in lawn care, the mower is equipped with a washout port on the deck. This allows for easy cleaning after mowing, ensuring that grass clippings do not accumulate and impact the performance of the cutting deck.

In terms of aesthetics, the PPH20K46 offers a sleek design that is both functional and appealing. The bright yellow color is not only distinctive but also enhances visibility, ensuring that the mower is easily seen while in use.

Overall, the Poulan PPH20K46 combines power, efficiency, and comfort, making it an excellent choice for homeowners looking to maintain their lawns effortlessly. With its array of features and technology, it stands out as a reliable companion for any lawn care regimen. Whether you are tackling large swaths of grass or navigating intricate landscaping, the PPH20K46 is engineered to meet the demands of modern mowing.